powersoft D-Cell504 IS Instruction Manual

Tech Note’s
Number
Keep This Technical Note For Future Reference
1 Preliminary consideration
This article is related to the following products:
fD-Cell504
fD-Cell504 IS
2 Procedure
There are two methods to obtain the same result.
1.1 Method #1
You have to ground pin 16 on the CN1 connector, as shown in
FIGURE 1.
1.2 Method #2
You have to ground J1003 on the interface board, as shown in
FIGURE 2.
TECHNICAL NOTE #15 rev. 01
Energy save mode
How to have Energy Save mode manually activated
FIGURE 1: Grounding Pin 16 on CN1 Connector
FIGURE 2: Grounding J1003 on the interface board
© 2012 - 2013 Powersoft
powersoft_TN015_EnergySave_en_v1.0

Via Enrico Conti, 5
50018 Scandicci (FI) Italy
Tel: [phone]
Fax: [phone]
General inquiries: [e-mail]
Sales: [e-mail]
Application & technical support: [e-mail]
Service & maintenance: [e-mail]
www.powersoft-audio.com
© 2012 - 2013 Powersoft powersoft_TN015_EnergySave_en_v1.0