powersoft DigiMod IS integration kit Instruction Manual

Tech Note’s
Number
Keep This Technical Note For Future Reference
1 Preliminary consideration
This article is related to the following products:
fDigiMod 1000
fDigiMod 1500
fDigiMod 2000HV
The kit that allows to transform a DigiMod module to DigiMod
IS (integrated solution) is labeled KT000276, and comprehends:
fN°1 Heat Sink
fN° 1 interface (already mounted on Heat Sink)
fN° 1 DSP-C
fN° 1 PowerCon Blue (already mounted on Heat Sink)
fN° 1 PowerCon Grey (already mounted on Heat Sink)
fN° 6 Screws for xing DigiMod module on Heat Sink
fN° 2 Screws for xing DSP-C board on Heat Sink
fN° 1 Bolt for xing ground wire (on PowerCon connection)
to DigiMod module
2 Tools needed
fPhillips cross-wing screwdriver
3 Procedure
1. Fix the DSP-C on DigiMod SIMM board connector with the
two screws.
TECHNICAL NOTE #18 rev. 01
DigiMod IS integration kit
How to transform a DigiMod module to DigiMod IS (integrated solution)
2. Remove all jumpers located on DigiMod on CN18/CN17
FIGURE 1: phillipsscrewdriver.jpg
FIGURE 2: Installing DSP-C
FIGURE 3: Jumpers to be removed, overview
FIGURE 4: Jumpers to be removed, detail
© 2012 - 2013 Powersoft
powersoft_TN018_DigiModISKit_en_v1.0

3. Fix the DigiMod module on the heat sink with the six screws.
4. Fix the grounding with a bolt.
5. Connect the PowerCon mains on the DigiMod.
6. Connect the programming at cables from the interface to
the DSP-C on board.
7. The procedure is nished.
FIGURE 6: Fixing the grounding
FIGURE 7: Connecting the powercon
FIGURE 5: Fixing the module on the heat sink
FIGURE 9: Connecting the at cable
FIGURE 8: Jumpers removed
2

Via Enrico Conti, 5
50018 Scandicci (FI) Italy
Tel: [phone]
Fax: [phone]
General inquiries: [e-mail]
Sales: [e-mail]
Application & technical support: [e-mail]
Service & maintenance: [e-mail]
www.powersoft-audio.com
© 2012 - 2013 Powersoft powersoft_TN018_DigiModISKit_en_v1.0