Premium Poly Patios AD-0101 User manual

REV01-8/19
FANBACK ADIRONDACK
AD-0101
1 AD-0101 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com

A
a b c d e
B
C
D
E
F
G
f
Suggested Tools:
Drill, Plastic Mallet
PARTS
PART DESCRIPTION PART NO. QTY
A LEFT ARM ASSEMBLY SA-00405 1
B RIGHT ARM ASSEMBLY SA-00406 1
C FRONT LEG PRT-00006 2
D UNDER ARM SUPPORT PRT-00007 2
E ADIRONDACK SPREADER SS-22.187 1
F BASE ASSEMBLY SA-00001 1
G BACK ASSEMBLY SA-00008 1
HARDWARE PACK
PART DESCRIPTION PART NO. QTY
a 5/16" X 2-1/8" CHAIR BOLT H-0000-CB516218 2
b 5/16" X 1-1/2" CHAIR BOLT H-0000-CB51615 6
c #8 X 2" TORX SCREW H-0000-S82 4
d #8 X 1-1/2" TORX SCREW H-0000-S815 2
e DOUBLE SCREW H-0000-DS 2
f T20 & T25 TORX BIT H-0000-CTD 1
AD-0101 Assembly 2
1-877-904-1234
www.Poly-Lumber-Furniture.com

C
A
e
D
5.
Repeat step 1-4 with Parts B,C,& D. These
assemblies will be used in step 7.
T20
c
x4
D
Please read entire instructions
before beginning
4.
Using Hardware C attach Part D
as shown.
3.
Place Part D in pre-cut slot as
shown.
2.
Rotate Part C clockwise until
tight in the orientation shown
1.
Connect Part C to Part A
using Hardware e as shown
3 AD-0101 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com

Tip: If the seat
back is a little
tight going into
the seat base,
partially loosen 2
of the seat
screws to allow
the base legs to
open, insert the
seat back and
then re-tighten
the screws.
G
F
b
x4
G
b
x1
a
x1
e
E
6.
Attach Part G to Part F
using 4 of hardware b.
Tip: When installing the chair bolts in Steps
6 & 7, insert the bolt into the hole, align it
with the nut and finger-tighten the bolt a
couple of turns into the nut before driving
with a drill. This will help to reduce the risk
of cross-threading.
7.
Turn the back/seat assembly on
it's side. Lay one arm/leg assembly
from steps 1-5 on the back/seat
assembly and bolt together using 1
each of hardware a & b as shown.
Flip the chair to the opposite side
and repeat.
8.
Assemble Part E into the chair. Insert
the tenon into the slot in one leg. Then
with slight pressure on the opposing leg,
push the opposite side of Part E into its
corresponding slot. Screw in place using 2
of hardware e.
4 AD-0101 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com