Premium Poly Patios Luxcraft Crestville Classic CV-5CPG User manual

5' Classic Poly Glider
(A) - Seat Assembly
(B) - Back Assembly
(C) - Glider Base right side
(D) - Glider Base left side
(E) - Bearing Supports
( ) - Headboard
(G) - Armrest Assembly right side
(H) - Armrest Assembly left side
(I) - ront & Back Crosspieces
(J) - Crosspiece Support
(K) - Lintels
Hardware
2 - 5/16" x 4" Bolt
2 - 5/16" x 3" Bolt
8 - 5/16" x 2 1/2" Bolt
4 - Large Nut (3/8")
12 - Small Nut (5/16")
32 - Washer
8 - 2 1/2" Screws
48 - 2" Screws
8 - 1/2" Screws
A.
B.
C. D.
E.
F.
G. H.
I.
J.
1. Attach (K) ront Crosspiece to Glider Base Sides
using fourteen 2" Screws.
**Be sure to matc all letters and/or numbers**
2. Attach (K) Back Crosspiece to Glider Base Sides
using fourteen 2" Screws.
**Be sure to matc all letters and/or numbers**
3. Attach (I) Crosspiece Support between Crosspieces
and attach using eight 2" Screws.
**Be sure to use all letters and/or numbers**
K.
2" Screws
2" Screws
2" Screws
2" Screws
Premium Poly Patios - Poly Lumber Furniture
www.Poly-Lumber-Furniture.com

4. Attach (E) Bearing Supports to Glider Base
Bearing Arms using four 2 1/2" Screws on each side.
**Be sure to matc all letters and/or numbers**
2 1/2" Screws
5. Attach Armrest Assemblies to each side.
Assembly order is: Was er - Armrest Assembly - Was er - Large Nut
Washer
Washer
Armrest Assembly
Large Nut
7. Attach (A) Seat Assembly to (B) Back Assembly
using four 2 1/2" Bolts. Use two bolts in center
supports and one in top hole per outside supports.
**Be sure to matc all letters and/or numbers**
8. Slide assembled Seat & Back between Armrests
and install 4" Bolts in back upright and bottom
hole of seat assembly
on each side.
**Be sure to matc all letters
and/or numbers**
9. Attach seat to front leg using 3" Bolts. Attach
Armrest to back support using 2 1/2" Bolts.
*Hex Head Bolt require 2 Was ers - between bolt ead - product & nut - product.*
*Hex Head Bolt require 2 Was ers - between bolt ead - product & nut - product.*
*Hex Head Bolt require 2 Was ers - between bolt ead - product & nut - product.*
10. Attach (J) Lintels to each side using 2" Screws.
**Be sure to matc all letters and/or numbers**
2" Screws
6. Attach ( ) Headboard to (B) Back Assembly using
eight 1/2" screws on backside.
**Be sure to match all
letters and/or
numbers**
Outside
Center
Premium Poly Patios - Poly Lumber Furniture
www.Poly-Lumber-Furniture.com