8
7. Installing and Removing the Accessories
8. The following cases are not malfunction
1. To dismantle the slide shelf: fold
the shelf, then pull it straight upward
flatly. Installing it just in the opposite
way.
3. To dismantle the flexible pocket:
pull out the tray first then draw the
pedestal of the pocket outward.
Don't dismantle the tray and the
pedestal at the same time.
1. The sides of refrigerator heat up. While the condenser is working, but this will not
influence on storage performance.
2. It takes a span of time for the temperature of the freezer and refrigerator compartments
to become cold while the refrigerator is working: If the temperature of the two
compartments are higher while he refrigerator is working, it takes a span of time for the
temperature of the two compartments to decrease.
3.The surface of the compressor becomes hot: It is normal for the surface of the compressor
to get hot in good working condition. Don't touch it with your hands.
4.When you hear a sound like water flowing:
The sound like water flowing is actually the refrigerant(cooling gas) flowing. It does not indicate
a malfunction.
2.If you need to replace the lamp,
pls follow to below instruction,
.Screw out the setscrews under the
lampshade.
.Turn the lampshade up at 90
degrees at the bottom gently
.Replace the used lamp with new
one.
.Turn the lampshade down to the
original position and tighten the
setscrews.
4.The drain pan is installed onto the
compressor. When uninstall the
drain pan:
a. remove the back cover;
b. pull out the drain pan horizontally.
While dismantling, don't strike
the tube to avoid causing noises
at work.