Prestan Adult Manikin 2000 Series User manual

The PRESTAN Professional Adult Series 2000 Manikin Add-On Kit can be used to
upgrade any PRESTAN Professional Adult or Jaw Thrust Manikin (2018 model or newer).
PRESTAN Professional Adult Series 2000 Manikin
Add-On Kit Installation Guide
Step 4
Once everything is loose, carefully remove
the rate monitor, spring and clicker assembly.
COPYRIGHT© 2021 PRESTAN PRODUCTS, LLC Series2000_AddOnKit_InstallationGuide_12721.V3.pdf
Step 1
Pull back skin of manikin torso and
remove the screw securing the rate monitor.
Step 2
Gently place flathead screw driver into slots,
pry to unsnap wire cover. Carefully remove
wire cover after all snaps are free.
Step 3
Place flathead screw driver into slots, pry
to unsnap clicker assembly. Carefully
remove after all three (3) snaps are free.
Tools Needed (not included) Breath ModulePiston Plug Add-On Kit

Step 9
Wrap cable around and over the base and
foam. Close chest making sure cable is
sandwiched between skin and foam.
Note: Skin may not fully latch on side where cable is routed.
Step 8
Insert screw and carefully tighten.
Note: Too much force will cause damage.
PRESTAN Professional Adult Series 2000 Manikin
Add-On Kit Installation Guide (continued)
COPYRIGHT© 2021 PRESTAN PRODUCTS, LLC Series2000_AddOnKit_InstallationGuide_12721.V3.pdf
Step 7
Lay wires flat in groove and snap
wire cover back into place.
Step 6
Insert Add-On Kit into circular cut out
and in left shoulder of manikin.
Step 5
Insert the piston plug as shown
below and press down firmly to secure.
To view the PRESTAN Professional
Series 2000 Add-On Kit installation video,
visit https://youtu.be/ei-95QyyAQk
or scan the QR code below:
.
Note: Using a smart device, point camera at
QR code and click on the link that appears.