Prestige Faux Woods User manual

3. Attach battery pack to connector
and insert battery pack into head rail.
NOTE: If mounting the battery pack
external to head rail is preferred,
contact dealer/distributor for battery
pack extension connector
2. Install 3 AA alkaline
batteries into bottom half of
remote control. The battery
orientation is shown in the bottom of the remote case.
CAUTION: Do not use lithium batteries in remote control.
3. Place front edge of the
top cover under the lip
of the cap and slide the
cover forward to the stop.
4. Squeeze the housings together and insert the screw to
secure remote control.
1. Locate female connector on top of motor and insert Satellite Eye
(included) into connector. (Fig. A)
Satellite eye may already be connected by fabricator
2. Install the blind into the window.
3. Attach the valance to the blind.
Attaching Satellite Eye to Valance
4a. Attach included foam tape to front of satellite eye. (Fig. B)
Place satellite eye as close as possible to corner of valance and attach
to inside of valance. (Fig. C)
(If desired, snap off plastic tab Screwport)
Attaching Satellite Eye to Top Treatment
4b. When using a fabric top treatment, attach a safety pin to the
screwport then to drapery making certain that the eye is visible or
attach to the wall or window seal with a small screw. (not included) An
additional 10” satellite eye is available for installations requiring a longer
cord. Contact dealer/distributor to order.
Satellite Eye Installation
Battery Installation
(Blind)
Battery Installation
(Remote Transmitter)
Operation Instructions for 2” Motorized Horizontal Blinds - Tilt System
1. Prior to installing the blind into
the window, remove the batteries
(4 AA Lithium) from their
packaging.
2. The batteries should align as
shown on the diagram inside the
battery holder.
LITHIUM
AA
LITHIUM
AA
LITHIUM
AA
LITHIUM
AA
1. Using a philips screwdriver, remove
the screw located towards the bottom
of the remote control face.
Fig. A
Fig. B
Fig. C
Prestige Window Fashions
195 Raritan Center Parkway, Edison, NJ 08818-0551 Tel: [phone] www.prestige.com Rev. 2 7/05
Tab/Screwport
Valance

In applications where blinds are installed close together, the “Cat-Eye” may be used to eliminate unwanted operation of a particular blind
or blinds by directing the infrared signal and providing more accurate control for individual blinds.
Using the Remote Control “Cat-Eye” Filter (Optional)
Operation Instructions for 2” Motorized Horizontal Blinds - Tilt System
Position “Cat-Eye” to the horizontal
position and insert into remote control.
Position “Cat-Eye” to the vertical
position and insert into remote control.
NOTE: Using the “Cat-Eye” filter will reduce the operating distance of the
remote control, however will provide better control of individual blinds.
Blinds Installed Above Each Other Blinds Installed Side by Side
Multiple Blind Operation (Synchronizing)
Trouble Shooting Tips
In applications where a blind is operating in the opposite direction, simply activate (1) blind individually until it reaches the identical
position of the other blinds(s).
EXAMPLE: Blind (b) is open, therefore operate blind (b)
ONLY until it moves to the position of blind (a).
NOTE: Removing the “Cat-Eye” may provide optimal
control when operating synchronized blinds.
Motor does not operate:
- Check the connection between the motor and the battery pack. Be certain the cable is properly plugged in. (Do not force)
- Check battery orientation in remote control and motor battery pack. Positioning of batteries should match accordingly.
- Be certain batteries are in good working order. (Remote control uses alkaline batteries only)
- Check the position of the IR receiver eye. (Must be visible) Black lense should be positioned towards user.
- Remote control should be pointed/aimed at the blind(s) intended for operation.
- Check the operation of the remote control by viewing the IR port hole. A red light should be visible when the control button is pressed.
Prestige Window Fashions
Blind (a)
Blind (b)
195 Raritan Center Parkway, Edison, NJ 08818-0551 Tel: [phone] www.prestige.com Rev. 2 7/05
For optimal customer satisfaction, the use of lithium batteries is recommended in all battery-operated systems (excluding remote controls). The use of lithium batteries helps ensure long-term battery life, depending
on usage. Extreme heat conditions may cause alkaline batteries to drain very quickly. Lithium batteries are able to withstand higher heat extremes than alkaline batteries therefore increasing life expectancy.