Pride Mobility Q 6000 User manual

MANUAL MODE
To put the wheelchair in manual
mode, push down the yellow
levers located behind each back
wheels. To put back in driving
mode pull the handles upwards.
TRANSFERS
Before transferring in or out of the
wheelchair, it is important to make
sure that these following safety
measures are applied.
1. The wheelchair must be TURNED
OFF before sitting in or standing
up from the wheelchair. You
must always make sure that all
the lights on the control box are
OFF before transferring in or out
of the wheelchair.
2. Before standing, the safety belt
must be unfastened.
3. The footrests must be swung to
the sides in order to free up
space in front of the seat. In or-
der to do this, you must press on
the GREY lever to swing foot-
rests to the sides.
4. You can swing the control box to the
side by pushing the lever underneath
the control box. Pull back the control
box to its original position before oper-
ating the wheelchair.
Contact us…
Technical Aid Services
[phone] #273
Constance-Lethbridge
Rehabilitation Center
7005, de Maisonneuve O.
Montreal Québec
H4B 1T3
Q 6000
MOTORIZED WHEELCHAIR
Grey lever

TURNING ON
To operate the wheelchair, you
must push up the lever located
on the left side of the control
box.
TURNING OFF
To turn off the wheelchair, you
must push down the same lever.
HORN
The button is located just under
the screen represented by a yel-
low horn.
DRIVING WITH THE JOY-
STICK
Wheelchair will advance in the
direction that you point the joy-
stick. The further you push the
joystick , the faster the wheel-
chair will advance.
SPEED PROFILE INDICATOR
The Q600 has five speed profiles
indicated in the bottom right of
screen by a number following
the letter ‘’P’’.
DISPLAY FOR BATTERY
CHARGE LEVEL
The display for the battery load
remaining in the wheelchair is
represented by a series of green
squares and also by a percent-
age number. As load decreases
so will squares and percentage
number.
BATTERY CHARGE
When half of the green squares
of the battery load have loose
their color, it is time to recharge
the battery.
Connect wire located at the back
of the wheelchair and connect it
directly in a standard outlet.
To ensure your safety and to
avoid damage to the wheelchair,
the battery must be charged in
one extended period rather
than short periods at a time.
On / off
Horn
CHANGING SPEED PROFILES
To change speed profiles, you
must push up the lever on the
left side of the control box. The
number following the ‘’P’’ letter
will change to show you in witch
profile you are in.
VARIABLE SPEED KNOB
Speed level is also adjustable
within each program by a dial
on the right side of the control
box and represented by a series
of yellow bars in middle of the
screen. Your cruising speed will
be indicated km/h by a number
below yellow bars.
Speed pro-
file indica-
tor Lever for
speed
change
Variable
speed
knob