Primera Signature II Specifications

SECTION II: RECORDING AND PRINTING
1. It is necessary to record and print the cards in two separate steps.
To record, first load the input bin with 35 blank CD-R Business
Cards. Next, create your recording job as described in the
Duplicator User’s Manual making sure to disable the Print option in
Prassi’s Recording Job Window.
2. Once your Business Cards have finished recording, reload them in
the input bin for printing. To print your card, use one of the software
templates included disc. In the driver you will need to enable the
Manual Load option and disable Clip Inner Circle as shown below.
Figure 4: Manual Load Figure 5: Clip Inner Circle
Please refer to the Duplicator Operator’s Manual for the rest of
the set-up procedure.
PN 510116-020121
Operator Instructions:
Business Card Adapter Kit
For Use with Composer™ Optical Disc Duplicator or
Conductor™ Printer Autoloader
Two Carlson Parkway North •Plymouth, MN 55447-4446 •U.S.A.
Phone: [phone] •763-475-6676 •FAX: [phone]
Web: www.primeratechnology.com

This sheet describes the installation and use of the CD-R Business Card
Adapter Kit for the Composer™ Optical Disc Duplicator and Conductor™
Printer Autoloader (referred to hereafter as the “Duplicator”).
NOTE: For printing purposes, the Business Card Adapter Kit is designed
to work best with the Signature®IV and SignaturePro®CD Color Printers
from Primera (referred to hereafter as “Printer”).
SECTION I: INSTALLATION
1. Make sure that in this box you have the following items:
• CD Business Card Input Bin
• Output Spindle
• CD-R Drive Ring
• CD Business Card Tray Template Assembly (2 pieces)
• 5 Printable Surface CD Business Cards
• Card CD-R Containing Software Templates
Figure 1: Input /Output Bins
2. Place Output Spindle in the center of the Output Bin on the left side
of the Duplicator.
3. Remove original Input Bin and place the CD Business Card Input Bin
on the right side of the Duplicator.
4. Install the CD Business Card Clamp Assembly in the Printer Tray as
shown below. The Front Template has molded pegs that mate with
locating holes found toward the front of the printer tray. The molded
Hook on the underside of the Rear Template rests on the metal
clamp located to the rear of the printer tray. When properly
installed, The metal clamp moves the Rear Template forward to hold
the card in place as the tray retracts into the printer.
Figure 2: CD Business Card Clamp Assembly
5. Install the CD-R Drive Ring in the CD-R Drive Tray as shown.
Figure 3: CD-R Drive Ring
6. Please note that it may be necessary re-align the Printer on your
Duplicator. Please refer top the Printer Alignment section in the Optical
Disc Duplicator User’s Manual. Once the printer is aligned, you are
ready to record and print CD-R Business Cards.
Business Card
CD-R Input Bin
Output Spindle