INSTALLATION
• Please make sure all devices you wish to connect have been powered off.
• Connect the source device (DVD/VCR etc) to the transmitter input using appropriate
composite video cable.
• Connect the source device audio output to the transmitter audio input RCA sockets
using an appropriate cable.
• Connect premium CAT5 cable up to 300m long to the UTP output of the transmitter
and to the input of the receiver.
• Connect the receiver output to the remote display using appropriate composite video
cable.
• Connect the receiver audio output to the audio input of the remote display.
NOTE: Premium quality CAT5e leads must be used to achieve the maximum audio/video
quality and stability over greater distances.
• Connect the IR emitter to the transmitter IR jack socket and place the sender close
to the source equipment IR receiver.
• Connect the IR receiver to the receivers IR jack socket and locate the sensor so it is
in line of sight of the remote control.
• Connect the PSU output to the power in socket on the receiver and plug in to the
mains supply and turn the power on.
• When the IR receiver receives a signal from the remote control the blue LED on the
sensor ashes.
NOTE: A double IR emitter is supplied so 2 source devices can be controlled so a splitter
or switch can be used to attach 2 source devices if required.
3
SPECIFICATIONS
Input connectors Standard RCA female jack sockets
Output connectors Standard RCA female jack sockets
Extension cable Cat5e RJ45 UTP
Bandwidth Video - 12MHz Audio 50Hz~15KHz
Impedance
Video 75ohm unbalanced
Audio 600ohm unbalanced
UTP 100ohm balanced
Operating temperature 0 to 70oC
Humidity 10 to 85% (no condensation)
IR frequency range 34kHz to 60kHz
Transmit frequencies 38kHz and 56kHz
Range 40ft @38kHz and 25ft @ 56kHz
• Use a soft cloth to wipe off any dust. If the device is very dirty, use a damp cloth and
wipe dry.
• Do not use any chemicals, abrasives or solvents that could damage the casing.
MAINTENANCE
