2
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
When using electrical appliances basic safety precautions should always be followed.
• To prevent fire or shock hazard, do not expose this product to rain or moisture.
• Beware of static electricity which may damage the device. Use ESD precautions
when installing.
WHAT'S INCLUDED
• VGA UTP Transmitter Unit
• VGA Receiver Unit
• 5V DC 2A PSU x 2
• Instruction manual
• Extend VGA video and stereo audio signal max up to 300m over one UTP cable.
• Adjustment of GAIN and PEAK to adapt for the different length of UTP cable.
• GAIN: Brightness adjustment.
• PEAK: Skew adjustment.
• Supports resolution max up to 1920x1200.
• Dual output at local unit: 1 x VGA output for source, plus 1 x UTP output for
connection to remote receiver.
• Works with monitors, projectors, HDTV, and flat panel displays
This unit combines split function and extension function. It distributes the input VGA
signal and audio signal into the local and remote outputs simultaneously. The receiver
works with the sender as a full functional module by receiving the distributed signal
using Cat5 network cable from the sender, and transmits it to display.
Use only high quality Cat5 cable to extend up to 300 meters.
OVERVIEW
FEATURES
INSTALLATION
• Connect the source device using suitable VGA cables to the input port on the
transmitter unit.
Connect the local display to the VGA output on the transmitter if required.
• Connect the transmitter output UTP port to the UTP input port on the receiver.
• Both transmitter and receiver have audio 3.5mm jack sockets so monitor speakers
can be connected to monitor the source and remote if the displays do not have
audio function via VGA.
• Connect the remote display to the receiver VGA output port.
• Connect both the 5V DC PSU outputs to the transmitter and receiver power input
ports and turn on the power switch and the power indicators will illuminate.
• The source VGA signal will be displayed on the remote output display.
• Adjustment of gain and peak can be made using the adjusters on the side of the
receiver using a small screwdriver to optimise the display quality.
