Promolife H2 User manual

HYDROGEN INHALATION SYSTEM
MANUAL
www.promolife.com 1-888-742-3404 [e-mail]
8
H2 HYDROGEN INHALATION SYSTEM 8
PARTS LIST
If you are missing any of
these parts, please
contact Promolife at
1-888-742-3404 or
[e-mail].
HYDROGEN SYSTEM PITCHER FUNNEL
TDS PEN
H2 CAP O2 CAP
HYDROGEN CANNULA
POWER SUPPLY DRAIN TUBING
WATER BUBBLER TUBING
May vary based on availability
HYDROGEN/OXYGEN CANNULA

H2 HYDROGEN INHALATION SYSTEM 2 H2 HYDROGEN INHALATION SYSTEM 7
CONTENTS
Parts List.....................................................................................................................8
Safety..........................................................................................................................3
Unit Diagram ............................................................................................................3
Control Panel ............................................................................................................4
Instructions for Use.................................................................................................4
Draining and Cleaning ...........................................................................................6
Troubleshooting ......................................................................................................6
Specications ...........................................................................................................7
Principles of Hydrogen Production.....................................................................7
SPECIFICATIONS
Voltage - Frequency AC 100-240V - 50/60 Hz
Gas Making Power 240W
Electrolytic Quality Puried/distilled water
Water Quality Requirements TDS ≤ 3
Hydrogen Purity 99.999%
Oxygen Purity 99.999%
Product Size 315x170x375mm
600 ml/m Hydrogen
300 ml/m Oxygen
PRINCIPLES OF HYDROGEN PRODUCTION
When water is placed into the tank and the machine is started, water passes through
an independent hydrogen production device in the machine. This module reacts
immediately to produce hydrogen and oxygen with a purity of up to 99.999%.
Flow Rate
Date of Purchase: ____________________________
Notes: _____________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________

H2 HYDROGEN INHALATION SYSTEM 6 H2 HYDROGEN INHALATION SYSTEM 3
SAFETY - READ BEFORE USE
• Place the machine upright on a level surface.
• Do not turn on the machine without water inside.
• Do not place the machine in direct sunlight.
• Drain the unit every 7-15 days.
• Do not use volatile chemical solvents to clean the machine.
• Do not use a power supply rated for less or more than the
power requirements of the unit.
• When the unit will not be used for some time, drain
remaining water and unplug it.
• When used with other electrical appliances, the devices
should be more than 30cm apart to avoid interference.
TROUBLESHOOTING
General Notes: If there is abnormal noise, smells or smoke, cut o the power
immediately and stop using the machine.
No hydrogen production/gas path leakage: Check the following: Whether the
hydrogen outlet pipe is leaking; whether the hydrogen outlet pipe is broken or
blocked; whether the liquid level is below the minimum limit; or if there is an
obvious air leak. Contact Promolife for instructions.
Display does not light up/low hydrogen ow: Check to make sure the power
cord is properly connected at both the machine and the outlet. If it is, contact
Promolife for assistance.
If you have any other issues: Feel free to contact Promolife for more specic
troubleshooting.
Note: When the machine is not
used for a long time, ll it with
water and start it at least once
a month for 30 minutes each
time.
Water Inlet
Stop/Start
Reset
Time Input
Display
Water Level Indicator
H2 O2
Heat Sink
VentDrain
Power
On/O
Water Inlet
DRAINING/CLEANING INSTRUCTIONS
1. If you don’t plan to use the machine often or simply need to replace the water,
you will need to drain the unit. Prepare a container to drain the water into.
2. Insert the drain pipe into the drain until you hear a click. The water will
automatically drain from the drain pipe.
3. Use a clean towel to wipe the surface. Do not use volatile chemical solvents to
clean.
A diagram of the control panel and its functions can be found on the next page.

H2 HYDROGEN INHALATION SYSTEM 4 H2 HYDROGEN INHALATION SYSTEM 5
2. Open the lid of the water tank lling port, add 1.5-1.9L of under 3 TDS
puried or distilled water, and close the lid. Do not exceed the highest water
level or use less than the lowest water level.
3. Allow the machine to stay o for 30-60 minutes.
4A. BREATHING HYDROGEN: If breathing hydrogen, replace the solid
lid with the lid with holes in it. Remove the cap from the hydrogen port. Attach
the Hydrogen Cannula to the hydrogen port. Leave the cap on the oxygen port.
Place the cannula on your head with the prongs inside your nose.
4B. BREATHING HYDROGEN & OXYGEN: If breathing hydrogen and
oxygen, use the solid lid and remove the caps from the hydrogen and oxygen
ports. Attach the H2/O2 Outlet Cannula to both ports. Place the cannula on
your head with the prongs inside your nose.
5. Turn on the power switch. The initial time is 000 minutes.
A. This model has one production mode, High. Press Time to set the timer
for 10-180 minutes. Press Start. You can press the Start button any time to
pause or unpause the timer. To reset, simply press the Reset button.
6. When the machine starts, the gas will begin to ow after 30 seconds.
7. After use, unplug the machine.
BREATHING INSTRUCTIONS
This system produces a steady stream of 99.999% pure hydrogen at 600ml/
minute. In addition, it can produce a steady stream of 99.999% pure oxygen at
300ml/minute. The total combined ow is 900ml/minute.
This machine provides two options:
A. Breathe pure hydrogen
B. Breathe a combination of pure hydrogen and oxygen. Hydrogen
and oxygen combined is referred to as Brown’s Gas. The combination is
66% hydrogen and 33% oxygen.
1. Connect the power cord to the machine, then plug the cord into your outlet.
Do not run the unit without water inside.
CONTROL PANEL
Water Level
Stop/Start
Indicator
Stop/Start
Reset
Time Display
Time Setting
DRINKING INSTRUCTIONS
This system will allow you to drink hydrogen-rich water. To do this, set up the
machine as you would to breathe hydrogen. Instead of attaching the cannula,
attach the tubing with bubbling stone to the hydrogen port. Place the other end
of the tubing into a vessel of water. Bubbling stone should be in the water.
Turn on the power switch. The initial time is 000 minutes. Press Time to set the
timer for 15 minutes and press Start. You can press the Start button any time to
pause or unpause the timer. To reset, simply press the Reset button.
When the machine starts, hydrogen will begin to ow after 30 seconds.
When the timer is done, turn o the machine and unplug it. Drink your hydrogen
water within a short period of time.
USING THE TDS MONITOR
This machine is meant to be used with water that is under 3 TDS (Total
Dissolved Solids). We recommend using distilled water. To test your water,
remove the bottom cap of the TDS pen, turn the pen on, and place the end in
the water for at least ve seconds. If the number is higher than 3, you should
replace it with lower TDS water.