Prorack K704 User manual

K704
Fitting Kit (Refer to line drawing instructions)
EN Fitting Instructions for Basic Carrier
x 4 x 2 x 2 x 4
x 4 x 1 x 4 x 4
x 4 x 8
Revision No: 5E 1

Fitting Kit (Refer to line drawing instructions) K704
MAX kgs (lbs)
W/P WHD
2

Fitting Kit (Refer to line drawing instructions) K704
X
A B C 1 2 3
3

Fitting Kit (Refer to line drawing instructions) EN
K704
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
●This kit fits type A, B, C and D.
●Use keys to remove covers.
4

Fitting Kit (Refer to line drawing instructions) EN
K704
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
●Attaches to factory-fitted mounting points
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Adjust crossbar in or out to suit vehicle.
Refer to the crossbar instructions for
crossbar adjustment.
5

Fitting Kit (Refer to line drawing instructions) EN
K704
●Remove plastic clamp block by gripping bar
leg with fingers and push firmly with
thumbs until clamp block drops out behind
leg.
●Select plastic internal block (from fitting kit)
and insert into foot.
●Repeat for all legs.
●Apply protective strip to roof of the vehicle
as shown.
Trim if required.
6

Fitting Kit (Refer to line drawing instructions) EN
K704
Fitment
●Open or remove fixed-point covers.
●Ensure rubber gasket is pulled away from
fixed point block when installing clamp.
●Place clamp into position as pictured.
●Ensure spring washer is between clamp
and the head of the screw.
●Using 5mm Hex Key supplied with this kit,
fully tighten to 5Nm (3.7 ft lb) hand tight.
●Repeat for all four positions.
●Assemble as shown.
7

Fitting Kit (Refer to line drawing instructions) EN
K704
●Refer to the underside of the pad for the
part number.
●Letters refer to the pad part numbers and
position.
●It is important to put the pads in the correct
position on the vehicle.
●Pad Part Number:
A = 235A
B = 236A
●Fit pad carefully over fixed point and clamp
screw.
●Ensure the fixed-point covers sit vertically
in the recess in the pads.
8

Fitting Kit (Refer to line drawing instructions) EN
K704
●Place crossbars on pads ensuring the pads
fit into the holes underneath the foot and
the grubscrew passes through the hole in
the foot.
●Repeat for all four positions.
●Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
●Place washer over clamp thread as shown.
●Ensure that tab is inserted into clamp
block.
9

Fitting Kit (Refer to line drawing instructions) EN
K704
●Tighten the plastic knob. The side with the
nut showing should be facing up.
●Ensure the plastic knob is in the position
shown when fully tightened.
●Repeat for all legs.
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
10