Punair TIG Series User manual

Smart Welder-TIG Series
1
TIG200A
Top Features
 High current range of 200 amps highly fit for the precision welding
 MMA current range of 170 amps provides the ability to weld the 3.2 electrode
 Multi-function: Continuous and Spot TIG,MMA process
 Convenient LED operational interface. Automatically matching welding parameter
 Overheat,over-current and over-voltage detection,anti-shock and anti-sticking functions
 IP21S classification to ensure reliability in harsh and demanding environmental conditions
Technical
Parameters
Technical
Parameters
Input Power
220V(±15%)/1Ph/50HZ/60HZ
Efficiency (%)
≥80
Rated input current (A)
26
Insulation grade
F
Rated Output Current /Voltage/Duty Cycle
8-200A/18V/60%
Housing protection grade
IP21S
MMA Output (A)
30-170
Net Weight (kg)
6.25
No load loss (W)
40
Dimensions H×W×D (mm)
400 x 159 x 300
Power factor
≥0.7

Smart Welder-TIG Series
2
ACCESSORY DRAWING
MIG Torch Electrode holder with cable Earth clamp with cable Connector assembly way Internal hexagonal wrench
Function description
1
Plate thickness indicator
11
①current adjustment knob
②Press to switch functions
2
Post Flow
12
Digital ammeter
3
Pre Flow
13
Argon welding torch interface
4
Current adjustment indicator
14
Negative output terminal
5
TIG welding light
15
The welder controls the socket
6
Manual welding indicator light
16
Positive output terminal
7
Spot
17
Earth connecting screw
8
protection lamp
18
Power switch
9
Power lamp
19
Air intake
10
Input voltage indicator light
20
Input power line

Smart Welder-TIG Series
3
INSTALLATION INSTRUCTION
Long connecting cable can affect the ARC start character and stability of welding performance, so please use the recommended cable length, and in order
to reducing the voltage down, please use the large cable face:
1. Please use at least 6mm2 cable to connect the welder to the earth.
2. Please make sure the power supply is right match for the welder and install the torch, earth clamp according
to the right instruction；
1) Using the MMA function,please connect the earth clamp and electrode holder according to the nature of
electrode, and tighten the connector.
2) Using the TIG function,please following the installation instruction to install the the torch and tighten it.
3. For the earth clamp, please let the connector connect to “+”, and the other side connect to the workpiece.
4. Before using the welder, please check the cable is right connected as the following picture and tighten them.
5. Please pay attention to polarity, since there are two connecting method for MMA process.① positive pole connecting method, earth clamp connect to “-”
and electrode holder connect to “+”;②negative pole connecting method, earth clamp connect ot “+”and electrode holder connect to “-”.
Please noted that which connecting way would be used is up to the workpiece processing requirement, if using the wrong connecting way, it will occur
some phenomenon.