PAGE 2 OF 2 0921 IH-9593
INSTALLATION CONTINUED
INSTALLING WITH TAPE
1. Clean installation
surface with an
alcohol pad. Allow
surface to dry
for 60 seconds.
Peel paper off
installation tape
and press firmly
against installation
surface for 30
seconds. For
maximum adhesion,
wait 24 hours before
loading refill or
using dispenser.
(See Figure 5)
2. Close dispenser cover.
3. Install floor and
wall protector into
bottom of dispenser
by aligning plastic
tabs on protector
with slots on
dispenser. Slide up
until tabs snap into
place.
(See Figure 6)
4. Open dispenser by
pressing release
button on bottom
and allow front
cover to descend
forward. Use
separate key tab to
unlock cover.
(See Figure 7)
5. Remove refill cap
and push new refill
into dispenser until
it clicks into place.
(See Figure 8)
6. Close dispenser cover.
7. Place hand in
middle of bar
and push several
times. Product will
dispense as bar is
depressed.
(See Figure 9)
REFILL REPLENISHMENT
1. Open dispenser by pressing release button on
bottom and allow front cover to descend forward.
Use separate key tab to unlock cover.
2. Remove empty refill and recycle.
3. Remove fill cap and push the new refill into
dispenser until it clicks into place.
4. Close dispenser cover.
5. Place hand in middle of bar and push several times.
Product will dispense as bar is depressed.
Figure 5
Figure 6
Figure 7
Figure 8
Cap
Refill
Figure 9
Bar
-800-295-551
