Plug in power supply
and secure with
retaining screw
IQ PANEL QUICK INSTALL GUIDE
WARNING: DO NOT CONNECT TO A RECEPTACLE CONTROLLED BY A SWITCH OR HIGH VOLTAGE
GOT QUESTIONS?
CONTACT TECH SUPPORT
Remove retainer screw
from panel top
Pull back plate off
gently
Hook panel stabilizer
strap onto back plate
Connect wires.
DCIN+ to Positive
DCIN- to Negative
Connect battery
NEVER DISCONNECT
AFTER INSTALLATION
Tilt panel upward onto
back plate until it snaps
in place
Replace retainer screw
and tighten
Connect power supply
Positive to +
Negative to -
Insert SD Card in slot on
back.
Settings
(default passcode is 1111)
“Tamper” Sensor
by opening case
Repeat this process with
each additional sensor
Select the desired network.
Enter Wi-Fi password if required.
Type Name
Type User Code
Select user type
Touch “Load from SD Card”
Replace all or add to library
FOR MORE DETAILED INSTRUCTIONS REFER TO THE IQ PANEL
INSTALLATION MANUAL ON DEALERS.QOLSYS.COM
Document#: IQPANEL-QG-10-13
Revision Date: 11/4/13
Qolsys Part #: QS-9004-VRZ
Disconnecting the battery may
result in data corruption, panel
failure, and a void of warranty.
Security Signaling Residential Fire Alarm and Security Equipment
ETL Listed
Conforms to ANSI/UL Standards
IMPORTANT:
ONLY USE
PROVIDED
POWER
SUPPLY
DO NOT
DISCONNECT
BATTERY
Conforms to ANSI/UL Std. S985. 1023. & 1635
Certified to ULC Sub. C1023 & ULC Std. S545
Qolsys Inc. proprietary. Reproduction without permission is not permitted.
Make adjustments
as needed
Make adjustments
as needed
Repeat this process with
each additional device
NOTE: If the device does
not learn in you may need
to “Delete Device” first.
See installation manual
for detailed steps
NOTE: Image Sensors are placed in
“pairing mode” by removing and
replacing the batteries or pressing
the button inside the hole on the
front of the sensor.
Photos must be less than 1MB in size
and saved in “DCIM” or “Photos” folder
Edit photo frame settings
Adding Security
or Image Sensors
