Quantum FastStor 2 User manual

TM
FastStor 2 Quick Start Guide
4
4
To power up the autoloader, use the
eraser end of a pencil or something
similar to press the left side of the
power switch.
9
Repeat until all desired slots are
filled.
Press NEXT or PREVIOUS until the
desired target slot number is
displayed. Press ENTER.
7
6Press NEXT or PREVIOUS until
IMPORT displays. Press ENTER.
2
Connect a SCSI cable between
the autoloader and the host system.
(2)
3
Connect a second SCSI (3) cable or
a terminator to the open SCSI port.
1
3222
When the mail slot opens, insert a
cartridge into the mail slot.
8
1Connect the AC power cord to the
FastStor 2 and then to the AC outlet.
(1)
5
On the Operator Panel, press NEXT
or PREVIOUS until COMMANDS
displays on the Operator Panel.
Press ENTER.
CANCEL ENTER
READY/
ACTIVE
CLEAN
DRIVE
MEDIA
ATTENTION
ERROR
PREVIOUS NEXT
COMMANDS
- - - - - - - -
CANCEL ENTER
READY/
ACTIVE
CLEAN
DRIVE
MEDIA
ATTENTION
ERROR
PREVIOUS NEXT
IMPORT TO:
SLOT 1
Your FastStor 2 is now ready to
perform a backup or restore operation
via your host system.
11 Verify your backup software. Note that
the default autoloader SCSI ID is 0
and the default drive SCSI ID is 5.
10 Power up your host system.
6-00516-01 Rev. A

Selected Indicators and Controls
For a summary of common operations, consult the
FastStor 2 Installation and Operation Guide.
LEDs
Error
Clean tape drive
Ready or active
Media attention
Buttons
Press CANCEL to clear operation modes or command
execution.
CANCEL
Press PREVIOUS/NEXT to view options within
a selected mode.
PREVIOUS
NEXT
Press ENTER to select operations or to clear
error conditions.
ENTER