Queclink GL501MG User manual

GL501MG GL501MG_T
GL501MG_S User Manual
Version: 1.00

GL501MG GL501MG_T GL501MG_S User Manual
Contents
0. Introduction .................................................................................................................................. 1
1. Product Overview .......................................................................................................................... 2
1.1. Product Appearance ........................................................................................................... 2
1.2. Key Description................................................................................................................... 2
2. Getting Started .............................................................................................................................. 3
2.1. Opening and Closing the Case ............................................................................................ 3
2.2. Turning on/off the Device .................................................................................................. 3
2.3. Installing a SIM Card ........................................................................................................... 4
3. Installation Precautions ................................................................................................................. 5
4. Troubleshooting and Safety Info ................................................................................................... 6
4.1. Troubleshooting ................................................................................................................. 6

GL501MG GL501MG_T GL501MG_S User Manual
1
0. Introduction
GL501MG GL501MG_T GL501MG_S is an IP67 waterproof GNSS tracker that features up to
900 days standby time powered by internal batteries and supports wireless charging. The
device is ideal for lot management and other tracking applications that require real-time
monitoring on temperature and light. GL501MG GL501MG_T GL501MG_S supports LTE Cat
M1/NB1 network on multiple bands for operation in America, Europe, and Oceania with a
fallback to GPRS.

GL501MG GL501MG_T GL501MG_S User Manual
2
1. Product Overview
1.1. Product Appearance
Figure 1. GL501MG GL501MG_T GL501MG_S Product View
1.2. Key Description
Table 1. GL501MG GL501MG_T GL501MG_S Key Description
Key Functions
To power on: Long press for more than 3 seconds
To check the device status: Press the key for one time
To power off (needs to be configured): Long press for more than 3s after
power on
Light Alarm Sensor
Key
LEDs
Light Tamper Sensor

GL501MG GL501MG_T GL501MG_S User Manual
3
2. Getting Started
2.1. Opening and Closing the Case
Figure 2. GL501MG GL501MG_T GL501MG_S Screw Position
To open/close the case: Unfasten or tighten the 4 screws at backside.
2.2. Turning on/off the Device
Figure 3. GL501MG GL501MG_T GL501MG_S Battery Switch and Key
To turn on: Long press the key for more than 3 seconds.
To turn off (needs to be configured): Long press for more than 3s after power on.
Power Key

GL501MG GL501MG_T GL501MG_S User Manual
4
2.3. Installing a SIM Card
Figure 4. GL501MG GL501MG_T GL501MG_S SIM Card Holder
Power off the device first and then install the SIM card.
SIM Card Holder

GL501MG GL501MG_T GL501MG_S User Manual
5
3. Installation Precautions
 Firmly install the device to a reliable surface to prevent falling off.
 Make the side with antenna face sky to have better signal reception.
 Do not install the device under metal surface or in enclosed environments having
difficulty in getting GPS and network signal.

GL501MG GL501MG_T GL501MG_S User Manual
6
4. Troubleshooting and Safety Info
4.1. Troubleshooting
Table 2. GL501MG GL501MG_T GL501MG_S Troubleshooting List
Trouble Possible Reason Solution
After the device is turned
on, the Status LED always
flashes quickly.
The signal is too weak. The
device isn’t registered to the
network.
Please move the device to a
place with good network
coverage.
Messages can’t be
reported to the backend
server by GPRS.
APN is not right. Ask the network operator for
the right APN.
The IP address or port of the
backend server is wrong.
Make sure the IP address for
the backend server is an
identified address in the
internet.
There is no response from
UART when the device is
configured by using UART.
The port is not ready or the
device is not powered on.
Please check the port and the
device to ensure they are
working properly.
The device can’t get GPS
fix. The GPS signal is weak.
Move the device to a place
under open sky.
It is better to make the side
with antenna face the sky.
FCC Regulations:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiated radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

GL501MG GL501MG_T GL501MG_S User Manual
7
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the user‘s authority to operate the equipment.
RF Exposure Information
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure
to radio frequency (RF) energy set by the Federal Communications Commission of the
U.S. Government.
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches)
during normal operation.
Local Representative Information
Company name: J&P GPS
Address: 1122 Hickory Way, Weston, FL 33327
Mobile: [phone]