Radio Flyer 910 User manual

#910 Connector Checks

First, try the following…
1. Remove the clear speed switch cover, set the car in speed 2
2. Insert the battery
3. Make certain the forward button is fully depressed
4. Hold the pedal down for a 3-5 seconds
5. If the car doesn’t move, test the horn and headlights, compare to the following
results
6. If the horn and lights don’t work, with the battery in the trunk, try charging
through the port on the back of the car, if the battery won’t charge in the car,
see Connector Check A
7. If you can charge the battery in the trunk, but pressing the pedal doesn’t
cause the lights on top of the battery to turn on, see Connector Checks B & C
8. If the horn and headlights do work, and the lights on top of the battery
illuminate when the pedal is pressed, but one or both of the wheels don’t spin,
refer to Connector Checks C & D
Functional Issue: Car Doesn’t Run

1. Flip your car on its side
2. Remove 8 screws from rear
valence panel
3. Press down on the snap to
remove the panel
1
2
3
6
4
5
7
8
Removing the Rear Panel

Complete this step if…
Battery will not charge while in the car
Skip this step if…
The battery charges in the car
Connector Check A
1. Try charging the
battery outside of the
car to make sure it
works
2. Unhook this connector
and then reconnect it
3. Try charging the
battery in car

Connector Check B
Complete this step if…
The battery charges while in the car, but
the car won’t function at all
1. Disconnect both
connectors
2. Reconnect both
connectors
3. Press the car’s pedal,
see if the lights on top
of the battery light up

Removing the Front Right Wheel
First pull the wheel cover
off. If you can’t do it by
hand, use a screwdriver
and pry the cover off.
Use an adjustable
wrench or a 17 mm
socket wrench to
remove the nut holding
the wheel on .
Remove the washer and
the wheel.

Connector Check C
1. Remove the front right
wheel
2. Disconnect all 3
connectors pictured,
hook them back up
3. Press the car’s pedal,
see if the lights on top
of the battery light up
Complete this step if…
The battery can be charged in the
car, but both wheels don’t spin
Skip this step if…
One wheels spins
1
2
3

Connector Check D
Complete this step if…
One wheels spins, or Check C has
been completed and the car still
doesn’t work
1. Disconnect both
connectors
2. Hook the connections
back up
3. Press the car’s pedal,
see if the wheels spin