Radio Shack 04A01 User manual

OWNER’S MANUAL — Please read before using this equipment.
©2001 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
LCD Jumbo Display Dual Timer/Clock
Your RadioShack LCD Jumbo Display Dual
Timer/Clock is a precise, dual-purpose time-
piece. Both timers can count hours, minutes
and seconds, up or down, from a specified
time. The metal stand lets you set the timer/
clock on a desk or table, and the clip and
magnet let you attach it almost anywhere.
Countup Timer — counts up to 29 hours, 59
minutes and 59 seconds.
Countdown Timer — counts down from 29
hours, 59 minutes and 59 seconds.
Minute and Second Increments — let you
count even small amounts of time.
Alarm — alerts you when the countdown
time elapses.
INSTALLING THE BATTERY
Your must install the supplied LR44 button-
cell battery before using your timer/clock.
1. Insert a coin
into the groove
on the battery
compartment
cover, turn the
coin counter-
clockwise, and
remove the
cover.
2. Insert the battery with the positive (+)
side facing up. The timer/clock beeps.
3. Replace the cover.
Cautions:
• Keep button-cell batteries away from
children. Swallowing a button-cell
battery can be fatal.
• Dispose of old batteries promptly and
properly. Do not burn or bury them.
Notes:
• If the timer/clock does not work when
you install the battery, remove and re-
install it.
• When the display dims or the alarm
weakens, replace the battery. For the
best performance and longest life, we
recommend using a RadioShack
alkaline battery.
SETTING THE CLOCK
1. Repeatedly press MODE until CLOCK
appears in the upper left corner.
2. Hold down CLEAR for about 2 seconds
until the display flashes.
Note: Repeatedly press CLEAR to
change between a 12- and 24-hour for-
HOUR
MINUTE SECOND
CLEAR
MODE
TIMER 2 TIMER 1

2
mat. PM appears for PM hours when the
12-hour format is selected.
3. Repeatedly press (or hold down) HOUR
until the correct hour appears.
4. Repeatedly press (or hold down) MINUTE
until the correct minute appears.
5. Repeatedly press (or hold down) SEC-
OND until the correct second appears.
Note: When you hold down MINUTE or
SECOND, the setting advances in incre-
ments of 10.
6. Press MODE or wait until the display
stops flashing. The clock is now set.
COUNTING UP
Each timer can count up to 29 hours, 59 min-
utes and 59 seconds. Then they reset and be-
gin counting from 0:00 00 again. You can
use the timers separately or together.
1. While CLOCK appears, press MODE.
COUNT UP1, COUNT UP2, and their
timers appear.
Note: If either timer does not show 0:00
00, press CLEAR to reset both timers.
2. Press TIMER 1 (for COUNT UP1) or
TIMER 2(for COUNT UP 2) to start
counting up.
Note: You can start COUNT UP1 and
COUNT UP2 at the same time by press-
ing TIMER 1 and TIMER 2 together.
3. Press TIMER 1 or TIMER 2 to stop count-
ing up. Press again to continue counting
up.
4. When both timers have stopped, press
CLEAR to reset them to 0:00 00.
COUNTING DOWN
You can use the two countdown timers for ac-
tivities that require a predetermined amount of
time, such as baking a cake or playing a
game. The timers count down in 1-second in-
crements.
Note: The maximum countdown time is 29
hours, 59 minutes and 59 seconds.
1. While CLOCK appears, press MODE
twice.
TIMER 1 and 0:00 00 appear.
Notes:
• To use TIMER 2, press MODE three
times.
TIMER 2 appears.
• To use both timers, press MODE four
times. TIMER 1 and TIMER 2
appear. Then press TIMER 1 or TIMER
2to set each timer.
2. Repeatedly press (or hold down) HOUR
until the desired hour appears.
3. Repeatedly press (or hold down) MINUTE
until the desired minute appears.
4. Repeatedly press (or hold down) SEC-
OND until the desired second appears.
Note: When you hold down HOUR,
MINUTE, or SECOND, the setting
advances in increments of 10.
5. Press TIMER 1 or TIMER 2 to start count-
ing down.
Notes:
• Both timers can be run at the same
time.
• To pause the countdown before the
timer reaches 0:00 00, press TIMER
1or TIMER 2. To resume the count-
down, press the same button again.

3
• To stop the countdown before the timer
reaches 0:00 00, press TIMER 1 or
TIMER 2, then press CLEAR. The timer
resets to 0:00 00.
When the timer reaches 0:00 00, the alarm
sounds for 1 minute and TIMES UP flashes
above the active timer. Then, the timer counts
up in 1-second increments. Press any button
to silence the alarm.
When the alarm stops, TIMES UP continues
to flash and the timer continues to count up.
To stop the count, press the active timer’s but-
ton. The timer resets to 0:00 00.
USING THE CLOCK AND
TIMERS
You can view the clock and use the timers at
the same time.
1. After you set the count up or countdown
timers, press MODE until CLOCK appears
in the upper left corner. The active
timer(s) flash.
2. Repeatedly press MODE to switch
between viewing the clock and the timers.
MOUNTING THE TIMER/
CLOCK
The magnet on the back of the timer/clock at-
taches to any metal surface, such as a refrig-
erator, oven or file cabinet.
You can also clip the timer/clock to a clipboard
or your clothing. Press down the upper end of
the clip, attach it to your clipboard or clothing,
and release the clip.
Using the Stand
1. Press down the
upper end of the
clip.
2. Use a pencil tip
to pull the small
stand out until it
fits onto the clip.
3. Set the timer on
a table or desk.
CARE
Keep the timer/clock dry; if it gets wet, wipe it
dry immediately. Use and store the timer/clock
only in normal temperature environments.
Handle the timer/clock carefully; do not drop
it. Keep the timer/clock away from dust and
dirt, and wipe it with a damp cloth occasionally
to keep it looking new.
Modifying or tampering with the timer/clock’s
internal components can cause a malfunction
and might invalidate its warranty. If your timer/
clock is not performing as it should, take it to
your local RadioShack store for assistance.
SPECIFICATIONS
Operating Voltage ............................ 1.25 to 1.65 V
Power Source .......... One LR44 button cell battery
Battery Life ......................................... About 1 year
Operating Temperature ............ 32–122 F (0–50 C)
Time Deviation ...................... 0.67 sec/day at 1.5V
Dimensions (HWD) .......... 1¼ ×25/8×33/8Inches
(32 ×67 ×86 mm)
Weight ................................................ 2.5 oz (71 g)
Specifications are typical; individual units might
vary. Specifications are subject to change and im-
provement without notice.
Clip
Magnet
Stand

63-898A
04A01
Printed in Hong Kong
RadioShack Corporation
Fort Worth, Texas 76102
Limited One-Year Warranty
This product is warranted by RadioShack against manufacturing defects in material and workman-
ship under normal use for one (1) year from the date of purchase from RadioShack company-owned
stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN,
RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUD-
ING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIM-
ITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES CONTAINED
HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABILITY OR RE-
SPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY
LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFOR-
MANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, IN-
CLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS
OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDEN-
TAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limita-
tion of incidental or consequential damages, so the above limitations or exclusions may not apply to
you.
In the event of a product defect during the warranty period, take the product and the RadioShack
sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, un-
less otherwise provided by law: (a) correct the defect by product repair without charge for parts and
labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase
price. All replaced parts and products, and products on which a refund is made, become the prop-
erty of RadioShack. New or reconditioned parts and products may be used in the performance of
warranty service. Repaired or replaced parts and products are warranted for the remainder of the
original warranty period. You will be charged for repair or replacement of the product made after the
expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse,
accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or
maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs
other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as
fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs
of product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
We Service What We Sell 12/99