Radio Shack Big Digit Timer User manual

©2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
63-938 OWNER’S MANUAL — Please read before using this equipment.
Thank you for purchasing the RadioShack Big Digit Timer. It
combines a simple design with advanced technology. You
can mount it on a wall, a metal surface, or place it on a desk
using the built-in stand. ±
#"+/2146#06"#
If an icon appears at the end of a
paragraph, go to the box on that
page with the corresponding icon
for pertinent information.
Rý— Warning #— Important
.
..
.— Caution °
°°
°— Hint
±— Note
TIMER — Counts down
from a specified number of
minutes (up to 99).
Large Liquid Crystal
Display — Lets you view
themonth,date, day of the
week, time, and
countdown timer at the
same time.
12/24 HR — View the
time in either a 12- or
24-hour format.
Three-Way Mounting —
Lets you mount the clock
on a wall, attach it to a
metal surface, or stand it
on a desk or table.
G
GG
Gand H
HH
H— Pressorhold
down to set the desired
timer minutes.
RESET—Erases
all stored
information.
MODE — Press to alternate
betweenhour, minute, year,
month, and date when
setting the clock time.
G
GG
Gand Hý
HýHý
Hý— Press to set the
hour, minutes, year, month,
and date values.
±"016'"±"
• The default clock setting is 1:00,
1/01, SAT, 00:00.
• Each time a button is pressed,
the clock beeps.
$KI"&KIKV"6KOGT
YKVJ"%NQEM

Installing the Batteries
2
+056#..+0)"6*'"$#66'4+'5
Your timer/clock requires three AAA batteries (not supplied)
for power. For the best performance and longest life, we
recommend RadioShack alkaline batteries. .
..
.
1. Remove the battery compartment cover by pressing the
cover’s tab in the direction of the arrow and lifting the
cover.
2. Insert three batteries in the compartment as indicated
by the polarity symbols (+and –) marked inside. The
clock beeps three times. The default month, date, day,
and time appear.
3. Replace the cover.
If the clock stops operating properly or the display dims,
replace the batteries. Rý#"±
5'66+0)"6*'"&#6'"#0&"6+/'
1. Press MODE. The hour digits flash.
2. Repeatedly press or hold down Gor Hon the back of
the clock to set the hour. Press 12/24 HR to switch
between the 12- and 24- hour formats. In the 12-hour
time format, FCý
FCýFCý
FCýappears when it is a PM hour.
3. Press MODE. The minute digits flash.
4. Repeat Steps 2 and 3 to set the minute, year, month,
and date. After setting the correct date, the clock
automatically sets the day of the week.
5. Press MODE when you are finished setting the clock.
75+0)"6*'"%1706&190"
6+/'4
The countdown timer lets you set a specific time to count
down from (up to 99 minutes). ±
1. Repeatedly press or hold down Gor Hon the front of
the timer until the desired countdown minutes appear.
2. Press TIMER to start countdown. To stop countdown,
press TIMER again. When the timer reaches 00:00, an
alarm sounds for one minute. Press any key to stop the
alarm.
."%#76+10".
• Use only fresh batteries of the
required size and
recommended type.
• Do not mix old and new
batteries, different types of
batteries (standard, alkaline, or
rechargeable), or rechargeable
batteries of different capacities.
• If you do not plan to use the
timer/clock for a month or more,
remove the batteries. Batteries
can leak chemicals that can
destroy electronic parts.
#"+/2146#06"#
When replacing the batteries,
install the new ones within 1
minute of removing the old
batteries. Otherwise, the clock’s
year, month, date, day of week,
and time memory are lost.
±"016'"±"
Do not press any buttons while
replacing batteries. If you do, the
stored time will be lost.
R"9#40+0)ýR"
Dispose of old batteries promptly
and properly. Do not burn or bury
them.
±"016'"±"
• To reset the countdown timer
when it is running, press TIMER
to stop counting, then hold
down TIMER to reset the time to
00:00.
• To reset the countdown timer
when it is not running and the
display is not set to 00:00, hold
down TIMER to reset the time to
00:00.
Installing the Batteries

Mounting the Clock
3
/1706+0)"6*'"%.1%-
75+0)"6*'"56#0&
You can set the clock on any level surface using the clock’s
built-in stand. Pull the stand out on the back of the clock as
far as it can go. Place the clock on the desk, shelf, or table.
75+0)"6*'"/#)0'65
The magnets on the back of the clock hold it on any metal
surface, such as a refrigerator, oven, or file cabinet. Simply
place the clock on a metal surface to mount it.
10"#"9#..
To mount the clock directly on a wall, you need two screws
(not supplied) with heads that fit the keyhole slots on the
back of the clock.
1. Drill two holes 49/16 inches (116 mm) apart.
2. Thread a screw into each hole, letting the heads extend
about 1/4inch (6.5 mm) from the wall.
3. Align the clock’s keyhole slots with the screws and slide
the clock downward to secure it.
4'5'66+0)"6*'"%.1%-
If the clock displays segmented digits, does not work
properly, or locks up, you can reset it. To reset the clock,
use a pointed object, such as a straightened paper clip to
press RESET. The clock beeps three times. Reset the date
and time. ±
%#4'
Keep the clock dry; if it gets wet, wipe it dry immediately.
Use and store the clock only in normal temperature
environments. Handle the clock carefully; do not drop it.
Keep the clock away from dust and dirt, and wipe it with a
damp cloth occasionally to keep it looking new.
5'48+%'"#0&"4'2#+4
If your clock is not performing as it should, take it to your
local RadioShack store for assistance. Modifying or
tampering with the clock’s internal components can cause a
malfunction and might invalidate its warranty.
±"016'"±"
• Resetting the clock erases all
stored information.

63-938
04A02
Printed in China
RadioShack Corporation
Fort Worth, Texas 76102
52'%+(+%#6+105
Power...............................................................Three AAA Batteries
Clock Accuracy .......................................................± 0.67 Sec/Day
Operating Temperature...................... 32°F to 122°F (0°C to 50°C)
Battery Life.....................................................................5000 Hours
Dimensions (HWD) ................................4 1/2×613/16 ×15/16 Inches
(114 ×173 ×24 mm)
Weight (without batteries)........................................ 7.76 oz. (220 g)
Specifications are typical; individual units might vary. Specifications
are subject to change and improvement without notice.
Limited One-Year Warranty
This product is warranted by RadioShack against manufacturing defects in material
and workmanship under normal use for one (1) year from the date of purchase from
RadioShack company-owned stores and authorized RadioShack franchisees and
dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS
WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MER-
CHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN
DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES CON-
TAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO
LIABILITY OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR
ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DI-
RECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR
ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT
LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF
TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the ex-
clusion or limitation of incidental or consequential damages, so the above limitations
or exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and the
RadioShack sales receipt as proof of purchase date to any RadioShack store.
RadioShack will, at its option, unless otherwise provided by law: (a) correct the defect
by product repair without charge for parts and labor; (b) replace the product with one
of the same or similar design; or (c) refund the purchase price. All replaced parts and
products, and products on which a refund is made, become the property of
RadioShack. New or reconditioned parts and products may be used in the perfor-
mance of warranty service. Repaired or replaced parts and products are warranted for
the remainder of the original warranty period. You will be charged for repair or replace-
ment of the product made after the expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts
of God, abuse, accident, misuse, improper or abnormal usage, failure to follow in-
structions, improper installation or maintenance, alteration, lightning or other inci-
dence of excess voltage or current; (b) any repairs other than those provided by a
RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries;
(d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs of
product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
12/99