Rainforest Automation EAGLE User manual

A new way to see your energy
Quick Start GUIDE
YOUR EAGLE™ INFORMATION LABEL
Located on the underside of your EAGLE™ is the Information Label that
identifies your individual device. You will need the three numbers
indicated below to register your device. Please make a note of them:
Cloud ID (6 characters)
Install Code (16 characters)
MAC Address (16 characters)
NEED HELP WITH YOUR EAGLE™?
For a full user manual, FAQs, and to contact support:
rainforestautomation.com/eagle_support
rainforestautomation.com
I N D I C A T O R
L I G H T P O W E R E T H E R N E T C L O U D Z I G B E E
Power is on. IP address
obtained. Connected to Cloud service.
Connected to the
electricity meter.
LED LIGHT INDICATOR KEY
LED lights on the front of the device give you a quick way to check the
status of your EAGLE™.
V2.3
WHAT’S IN THE BOX:
•EAGLE™ ENERGY MONITOR
•AC POWER ADAPTER
•ETHERNET CABLE
YOU WILL NEED:
•A FREE ETHERNET PORT ON A ROUTER CONNECTED
TO THE INTERNET
•A COMPUTER OR DEVICE WITH A WEB BROWSER
rainforestautomation.com

GET DIRECT ACCESS TO YOUR REAL-TIME
ENERGY INFORMATION IN THREE
EASY STEPS:
STEP 1: REGISTER WITH YOUR UTILITY
You will need to provide your MAC Address and Install Code from
the Information Label on the bottom of your EAGLE™. It may take
some time for your utility to enable your meter to connect to your
device. It is important to wait until this is complete before
proceeding to the next step.
STEP 2: PLUG IN YOUR EAGLE™
Connect the Ethernet cable to your router, and plug in the power
adapter. Use only the included adapter to power your EAGLE™.
If another adapter is used, it may cause permanent damage to
your EAGLE™.
It should take about two minutes for your EAGLE™ to boot up.
STEP 3: CONNECT TO THE CLOUD
Create your Cloud Account and connect to your EAGLE™ to start
viewing your energy data.
rainforestcloud.com
Click on the word “Register” in the lower right corner.
Fill in the registration information and click the blue “Register” bar.
Check your email to find the message from Rainforest Automation
with the subject line “Please confirm Your Registration”. Click the
link in the email.
Enter your email address and password. Click the blue “Submit” bar.
Click the blue “+ New Gateway” bar.
Enter the Cloud ID and the Install Code for your EAGLE™ (these
numbers can be found on the Information Label that is on the
underside of your device). Click the blue “Add” bar.
Click the connect icon ( ).
SEE THE FULL EAGLE™ USER GUIDE ON OUR WEBSITE:
rainforestautomation.com/eagle_support
CONNECTING TO THE CLOUD
Use your Web Browser to go to rainforestcloud.com