Before starting to Programme the RA-IBB
1) Ensure that if there is a Bridge on the system that “Wireless Rate Mode” is disabled.
This is set via the Bridge web pages:
For more information on how to access the Bridge web pages please refer to Appendix 1 of all
programming guides.
2) While addressing and programming the RA-IBB please ensure there is at least 2
meters between the RAMPI/Bridge and the Silent Gliss curtain/blind.
Addressing the RA-IBB
Open the project file for the installed Rako system and make sure that
Rasoft is connected to a communication device.
NB
The communication window at the bottom right should indicate whether a
device is connected or not. In this case a RAMPI is connected. For instructions
on how to connect to a communication device see Rasoft Pro programming
guides.
- Select “File” - “New device” to bring up the “New device Wizard” and choose “RA-IBB” from
the list.
- Choose a suitable device name.
- Associate the RA-IBB to a room from the drop down menu.
The room selected here will set the “Local Room” for this device.
- Once this screen appears press and hold the clear button on
the RA-IBB. After a few seconds it will enter setup mode and the
RA-IBB Version 1.0.1