Rapidline LAB ST User manual

Assembly Instructions:
Tools Required:
Screwdriver, Electric Drill, Pencil, Measuring tape/Ruler
*Tools are not included.
Skill Required:
The Assembly Skill Rating is a 5-point system that shows the degree of eort needed in assembling
a specic product. With 1 being easy for the average person and 5 requiring an expert.
For most products, two persons are recommended.
Time Required:
15 minutes
Easy Hard
Product Code : LAB ST
Product Name: LAB Stool
NOTE
• As this is a commercial product, some intermediate skills may be required.
• No pre-drill holes or markings are provided on our table or desk tops.
• Please check you have all hardware before assembling.
• If you are missing any hardware, please contact your Rapidline reseller. Please ensure you have the name of the item,
required hardware part and quantity.
• Please retain your receipt as proof of purchase to validate your warranty.
• Assemble on a clean, at, smooth surface such as a rug or carpet to avoid parts from being scratched.
• Remove all wrapping materials, including staples and packing straps before you start to assemble
• Keep all hardware parts out of reach of children.
CAUTION
• Heavy product. Do not attempt to lift or move without help
• Do not tighten screws and bolts until completely assembled.
• Do not use this product unless all bolts and screws are rmly secured and tightened.
WARNING
• If parts are missing, broken, damaged or worn stop using the product until all repairs are made.
• Failure to follow these warnings could result in serious injury.

1.
• Firmly insert gasli into
5-star base from above
• Insert the footring from
the top of the gasli
2.
• Slide the bar of the back into the in-
sert slot of the mechanism at the back
of seat, but rst pull out the plastic lug
then slide the bar in
3.
• Fit the seat on top of the gas li