Rapidline RSCWS181275M User manual

Assembly Instructions:
Tools Required:
Screwdriver, Electric Drill, Pencil, Measuring tape/Ruler
*Tools are not included.
Skill Required:
The Assembly Skill Rating is a 5-point system that shows the degree of eort needed in assembling a specic product.
With 1 being easy for the average person and 5 requiring an expert. For most products, two persons are recommended.
Time Required:
30 minutes
Easy Hard
Product Code : RSCWS181275M / RSCWS181575M / RSCWS181875M / RSCWS151575M
Product Name: Deluxe Rapid Span Corner Workstation
NOTE
• As this is a commercial product, some intermediate skills may be required.
• No pre-drill holes or markings are provided on our table or desk tops.
• Please check you have all hardware before assembling.
• If you are missing any hardware, please contact your Rapidline reseller. Please ensure you have the name of the item,
required hardware part and quantity.
• Please retain your receipt as proof of purchase to validate your warranty.
• Assemble on a clean, at, smooth surface such as a rug or carpet to avoid parts from being scratched.
• Remove all wrapping materials, including staples and packing straps before you start to assemble
• Keep all hardware parts out of reach of children.
CAUTION
• Heavy product. Do not attempt to lift or move without help
• Do not tighten screws and bolts until completely assembled.
• Do not use this product unless all bolts and screws are rmly secured and tightened.
WARNING
• If parts are missing, broken, damaged or worn stop using the product until all repairs are made.
• Failure to follow these warnings could result in serious injury.

Step 1.
Attatch Modesty Panels to legs and
centre pole using screws provided
Step 2.
Centre the top on frame then attatch
top to frame using screws indicated.
Note: it may be easier to do this upside down with the
top on a soft surface, and the frame centred upside down
on the top.
Use a pencil to mark the screw locatios and pre-dill
holes rst if necessary