Rapidline RR1 User manual

Assembly Instructions:
Tools Required:
Screwdriver, Electric Drill, Pencil, Measuring tape/Ruler
*Tools are not included.
Skill Required:
The Assembly Skill Rating is a 5-point system that shows the degree of eort needed in assembling a specic product.
With 1 being easy for the average person and 5 requiring an expert. For most products, two persons are recommended.
Time Required:
10 minutes
Easy Hard
Product Code : RR1
Product Name: Rapid Riser 1 - Medium
NOTE
• As this is a commercial product, some intermediate skills may be required.
• No pre-drill holes or markings are provided on our table or desk tops.
• Please check you have all hardware before assembling.
• If you are missing any hardware, please contact your Rapidline reseller. Please ensure you have the name of the item,
required hardware part and quantity.
• Please retain your receipt as proof of purchase to validate your warranty.
• Assemble on a clean, at, smooth surface such as a rug or carpet to avoid parts from being scratched.
• Remove all wrapping materials, including staples and packing straps before you start to assemble
• Keep all hardware parts out of reach of children.
CAUTION
• Heavy product. Do not attempt to lift or move without help
• Do not tighten screws and bolts until completely assembled.
• Do not use this product unless all bolts and screws are rmly secured and tightened.
WARNING
• If parts are missing, broken, damaged or worn stop using the product until all repairs are made.
• Failure to follow these warnings could result in serious injury.





 
!"
#$#








%!


&'
%&%


 &&
 
!"
(


!% 
' 
 "%

) *+,-

-7-
-2-
AC
x1
B
x1
x4
x1
x1
x2
Accessory Package List
Note: The drawings below are only for reference and may be slightly different with
the object, please in kind prevail. Any tools missing or installation problems,
please contact the customer service freely.
TOOLS
ASSEMBLY STEP 5
CAUTION
Adhesive buckle helps to make the cables tidy and cleanPlease leave
enough length of cable for height adjustment function, otherwise it
may cause unexpected lost.
This surface is with glue, helping to
fix the cable management on the table
Cable
Nylon ties
Technical Data
A: 3~15kg
B:<=2kg
A+B=3~15kg
A
B
Please do not exceed the
maximum bearing weight
WARNING
740
İ
150~500
580
560
680
590
610
İ
x8

#2#
#3#

 "&

&'%
&%

&&%&


4%



-5-
-4-
ASSEMBLY STEP 3
Based on the actual usage, press the handle grips both sides
simultaneously, and adjust the workstation to the proper height.
WARNING
Please do not put hands near the supporting bars, as they change
during adjusting and may hurt you.
ASSEMBLY STEP 2
a : Buckle decorative cover to the connecting arm.
b : Connect and fix the junction plate and keyboard tray by 8 screws and use
the cross screwdriver to fasten afterwards.
c,d:Hang the junction plate on the knob assembled and then tighten the
knob.
cTighten
a
d
Note: Loosen bolts to make sure the keyboard sits securely before tightening
b