RC4WD Trail Finder 2 User manual

1/10 SCALE 4x4 TRUCK KIT

RC4WD TF2
ii
Recommended Tools
Hex Drivers (1.5mm, 2mm, 2.5mm)
Thread Lock Cross Wrench
Long Nose Pliers
Tips for Assembly
Use good quality hex drivers to avoid stripping screw heads.
Use thread lock when putting metal screws into metal parts.
Note: Steps marked with an asterisk (*) require thread lock.
Use thread lock sparingly.
Do not over tighten screws otherwise you may strip the thread.

RC4WD TF2
iii
RC4WD Limited Warranty
All RC4WD products are warranted to be free of defects in materials and
workmanship when new. Our limited warranty does not cover damages due to
normal wear and tear, user error of assembly or installation, user
modifications, user's failure to perform routine maintenance, addition of
aftermarket parts or option parts. This warranty lasts as long as the original
purchaser owns the product. In the event of a defect under this warranty,
RC4WD will, at our discretion, replace the product, provided our inspection
indicates that an original defect exists. RC4WD reserves the right to replace
any product which is no longer available with a product of comparable value
and function. If RC4WD determines the repair is not covered under warranty
guidelines, we will contact you to discuss your options. If you have any
questions, please contact us via email at [email protected] .

RC4WD TF2
1
All of the hardware should be taken from Bag C
1 *
Steps 2 to 5 should be done on both frame rails
Metal parts can be found in parts Bag A
2 *

RC4WD TF2
2
Plastic parts can be found in parts Bag D
3
4
5

RC4WD TF2
3
6 *
7 *

RC4WD TF2
4
8 *
9 *

RC4WD TF2
5
10 *
11 *

RC4WD TF2
6

RC4WD TF2
7
12 *

RC4WD TF2
8
13
14 *

RC4WD TF2
9
15 *
16

RC4WD TF2
10
17
18
Attach bumper mount 2 on the rear of the chassis

RC4WD TF2
11
19 *

RC4WD TF2
12

RC4WD TF2
13
20

RC4WD TF2
14
21
Attach leaf springs to front and rear axles
Note: The smaller helper leafs can be fitted below the main leaf to stiffen the
suspension
22

RC4WD TF2
15
23

RC4WD TF2
16
24
Attach bumper mount 3 to the front of the chassis

RC4WD TF2
17
25
Attach dampers to both sides of the chassis