Real Spirit Aqua-Ionizer Pro ionHealth Touch User manual

Read Carefully
Before Initial Use Retain Manual for
Future Reference
OWNER’S MANUAL
Made in Korea
ionHealth™ Touch
WATER IONIZER
®
v. 1.0

2
Contents
®
Important Notice
How to Operate
Installation Details
Troubleshooting

3
Safety Suggestions
allow
done
Alkaline
it
water ionizer

4
Installation
Undersink
Note: a SMART FAUCET Kit must be purchased seperately for undersink installation.
Call [phone] to order.
• Correct water hardness is key in generating good alkaline/acidic water.
thoroughly.

5
Electrical Safety

LCD Touch Display
(Alkaline/Acidic Water)
6
Parts

7
Controller / Indicator
When this button/setting
is touched, selected
water will start to flow or
stop flowing.

Instructions for Use
8
Touch the “Alkaline” button to
select the desired level of alkaline
water. Whenever you touch it, the
Alkalinity is changed.
1.
When the desired level is selected,
touch the ON / OFF button and
enjoy the alkaline water.
2.

Touch the “Acidic” button to select the desired level of acidic water. Whenever you touch
it, the Alkalinity is changed from 1 through 5.
1.
9
Instructions for Use

10
How to Use
, at low flow rate.
IMPORTANT
Cthe
n
storing clear of water, drain hoses, lines, and filters.
• Replace filters if stored for a long period of time.
clean
only
time users of alkaline ionized water

11
Replacing Fuse
Unplug unit from power source before replacing fuse.
• Please do not use inappropriate water for drinking.
• Please do not use in high temperatures or high humidity.
• Please do not use the machine where affected by atmospheric pressure,
wind, sun, or salt.
• Do not use in places where gass is generated or in a chemical warehouse.
• Please do not use on a sloped or unstable surface.
• Do not use in low water pressure (under 14.2psi) and low
flow rate ( 1L/min or less).

Replace the filter in the following order after unplugging the power source and
closing the source water valve.
12
Replacing Filter
Please make
sure the filter
is locked
upward to
prevent any
leaks.
pictured.
down
3. Remove plastic end caps on the filter, two caps per filter
5.
4.

13
Installation

Step 1: Please be sure to fully unpack your ionHealth™ Silver and Smart Faucet. Remove
any stoppers on the water in/out lines. Tools Needed: Scissors, Slip Joint
Pliers.
Step 2: OPTIONAL: If your 5/16ths hose isn’t long enough Install the 5/16ths COUPLER
on the “IN” water line, between the cold water fitting and the “IN” water line.
Step 3: Feed the hoses and black cable down the hole in the sink attached to the faucet.
Mount the Smart Faucet into the hole.
Step 4: Under the sink, take the white hoses and black cable attached to the faucet and
feed them through the silver washer and brass nut.
Step 5: Screw on the brass nut to the Smart Faucet and tighten.
Step 6: Turn off the cold water and install the included Cold Water T Fitting. Unscrew
the COLD WATER connected metal hose, and place the T fitting in between.
Hand tighten, then re-install the COLD WATER metal hose.
Step 7: Remove the blue clip on the T fitting. Install the white hose to the Cold Water T
inlet by firmly pushing it in. Reinstall the blue clip. (Space before “Reinstall” &
Spelling of Reinstall)
Step 8: Take the hose we just connected to the T Fitting to the inlet, and insert it to the
IN - closest to the back of the machine and closest to the yellow sticker. Be
sure to push the hose in firmly for a secure connection.
Step 9: Cut the hose connected from the Cold Water T inlet, and install the included
Dust Filter with the Blue side closest to the T Fitting. Reconnect the loose hose
to the White side. Ensure the Arrow on the Dust Filter follows the flow of water
and make sure the hoses are connected securely to prevent any leaks.
Step 10: Take the 1/4in the smaller loose hose from the Smart Faucet and install it into
the OUT on the ionHealth™ Silver, next to the RED dot.
Step 11: Plug the black cable from the Smart Faucet into the TOP BACK of the
ionHealth™ Silver.
Step 12: Take the included Male Fitting from the parts bag, and screw it into the TOP of
the ionHealth™ Silver.
Step 13: Connect the remaining hose (5/16th) from the Smart Faucet into the TOP of
the ionHealth Silver.
Step 14: Turn on the ionHealth™ Silver
Step 15: Make sure your Smart Faucet is powered on and working.
Installation video: https://aquaionizerpro.com/pages/install
How to Install
14

Turn lever to open position
to allow water to flow
Check for leaks after installation
Turn the lever horizontal for
water to flow into the ionizer.
Turn the lever vertical for
water to flow though like
normal for your sink.
(Acidic)
IN
IN
15
Installation Method

16
Troubleshooting
generation Call [phone].
Call [phone].
Troubleshooting
issue
1-888-601-5886
Water has been cleaned by GAC(Granulated
Activated Carbon) material.

17
Specifications
110-240 Volts 50-60 Hz
2000-6000L depends on Water Quality
ionHealth™ Touch
Aqua Ionizer Pro®

18
Limited Lifetime Warranty:
Real Spirit USA, oers a Limited Lifetime Warranty on all its water ionizers to the original
consumer purchaser under the following terms and conditions:
VIP Limited Lifetime Warranty:
By Purchasing the ionHealth™ your warranty period is extended beyond the ‘Limited Lifetime
Warranty’ to a ‘VIP Limited Lifetime Warranty’ on parts and labor or a full unit replacement
should your ionHealth™ fail at any time now or in the future while in use by the original
purchaser.
Whether in the rst 5 years or subsequently, upon discovery of a product defect, you should
immediately notify Real Spirit USA via telephone or email the exact problem you are having
to the best of your knowledge. If it is determined to need additional diagnostic inspection,
then we will provide you a product return authorization and shipping instructions. You
should ship or deliver the product to the designated service location, accompanied by your
name, address and telephone number, proof of purchase date and a description of the defect.
The customer is responsible for the cost of shipping the unit to the service facility. However,
following repair or replacement, RealSpirit USA will cover the cost of shipping the unit back to
the consumer within the continental United States. Customers outside the continental United
States must also cover the cost of return shipping following repair or replacement.
The warranty does NOT include unusual wear, damage resulting from accident or unreason-
able use and also does not include replacement lters nor other disposable parts and
supplies. *Unreasonable use also includes using the unit outside of North America and in
countries were the voltage may be higher than 110/120 Volts, which is the normal operating
range of our products.** Additionally the warranty will become VOID should the case seal be
broken and the tamper system activated which shall indicate the unit cabinet was opened for
purposes other than authorized by the company. It should be noted that any electronic unit
should be serviced only by an authorized service technician duly certied by Real Spirit USA,
all warranties are non-transferable and remain registered to the original purchaser.
**Note: Please contact us for special 220/240 volt international models which may be
available for use outside of North America.
Limited Lifetime Warranty:

Aqua Ionizer Pro® water ionizers and lters are covered by our Limited Lifetime Warranty* Aqua
Ionizer Pro® or its parent company Real Spirit USA, Inc accepts no liability, nor oers any
warranty or remedy for damages of any kind in regard to water damage caused or reported to
be caused by leaks from hoses, ttings or directly from any of our products.
Further Real Spirit USA does not warrant or accept any liability in regard to installing our Ionizer
units, hoses, or additional valves or lters. Any such installation is at the sole responsibly of the
owner or the third-party installer, plumber or contractor.
The customer/ user by purchasing our products accepts full responsibility for ensuring that the
proper acceptable water pressure is present at the time of installation (as stated in the owner’s
manual). Water pressure is controlled by the supplier or the home owner and cannot be
controlled or guaranteed by Real Spirit USA or its aliates.
All installations should be approved by a nationally recognized P.I.P.E. or other certied
contractor.
-P.I.P.E. is the parent company of the National Inspection Testing and Certication Corporation,
known in the industry as National Inspection Testing Certication (NITC).
Once you have installed your unit, it is recommended that connections and connectors are
inspected by the owner on a regular basis. It is also recommended that if you are away from the
installation for longer than a 24-hour period that you turn o the water supply to your Water
Ionizer system as well as turn o the supply power to your unit.
Basic care and maintenance by the owner/ user of this equipment is entirely the responsibility of
the purchaser-owner/ user, as Real Spirit USA assumes no responsibility for misuse, faulty
installation, or variations in water pressure or quality.
Other than what is expressed in our products warranty, Real Spirit USA assumes no additional
liability for these foregoing statements or other ‘Acts of God’.
By acceptance of delivery, and the installation the Real Spirit USA products (lters, ionizers, and
accessories) you agree to hold Real Spirit USA harmless for any water damage caused by leaking
water or for any other reason.
*See warranty on previous page
Water Damage Liability Statement and Waiver
19

Any Questions?
[phone]
Aqua Ionizer Pro® is a division of Real Spirit USA, Inc.
320 South Rock Blvd Suite 210 • Reno NV 89502 • Ph 888.601.5886
www.AquaIonizerPro.com • [email protected]