RealFlame Fresno G1200 User manual

Model # G1200
Fresno Fireplace

2
Welcome to the Real Flame family of gel fuel products. If
you have questions please call customer service at
1-800-654-1704 or log on to www.REALFLAME.com
WARNINGS
1. Fireplace is designed to be used with Real Flame® gel fuel only. Do not use with any other gel fuel or any other
flammable liquid or gel.
2. Read entire label and instructions before using Real Flame gel fuel.
3. Make sure fireplace is set on a flat, level and stable surface. Keep fireplace stable at all times.
4. Make sure fireplace and gel fuel are burned on a flat and level surface.
5. Never leave a burning fire unattended, especially around children or pets.
6. Fireplace is not to be operated by children. Keep away from children and pets.
7. Exercise the same precautions as you would with any open fire.
8. When in use some surfaces will be hot, use caution.
9. Never touch logs, gel fuel cans or any other metal surfaces during or immediately after burning gel fuel. They will
be extremely HOT. Allow them to cool for 60 minutes before touching.
10. Do not burn more than three cans of fuel at once.
11. Do not place more than 15 lbs. of weight on the top of the fireplace at anytime.
12. Do not alter fireplace, metal firebox or log set in any manner.
13. Keep fireplace and gel fuel cans away from flammable materials at all times.
14. Do not store or use gasoline or any other flammable vapors, liquids, or materials in the vicinity of fireplace and
gel fuel.
15. Do not wear flammable or loose clothing when operating the fireplace.
16. Do not move fireplace while in use. Do not attempt to move or store the fireplace until 60 minutes after gel fuel
cans have been extinguished.
17. Do not burn trash, paper, or wood in the fireplace. Burn only Real Flame® gel fuel in the fireplace.
18. Do not burn gel fuel outside designated burn areas on the metal grate.
19. Do not put fireplace in an area with lots of traffic, such as a hallway or entryway.
20. In case of an emergency use a CO2 extinguisher to extinguish the fire.
21. Death, serious injury or damage to property may occur if the warnings above are not followed.
22. If for any reason you cannot follow these warnings please call us at 1-800-654-1704.
NOTICE: Buyer assumes all responsibility for safety and use
that is not in accordance with instructions and warnings.
Using your Fireplace
- Fireplace is designed to be used indoors, there is no need for ventilation.
- Use extreme caution while burning. Some surfaces become extremely hot during use.
- Follow all instructions included with gel fuel before use.
- Before using fireplace, be sure you have read and understand the step-by-step instructions.
- During the initial burn you may experience a slight odor. Odor is temporary and will be absent on following burns.

3
PARTS LIST
Number Description Part Number Quantity
1 Base Panel G1201 1
2 Left Outside Panel G1202 1
3 Right Outside Panel G1203 1
4 Left Front Panel G1204 1
5 Right Front Panel G1205 1
6 Left Inside Panel G1206 1
7 Right Inside Panel G1207 1
8 Upper Firebox Trim G1208 1
9 Left Center Panel G1209 1
10 Right Center Panel G1210 1
11 Top Panel G1211 1
12 Back Panel G1212 2
13 Shelf Panel G1213 4
HARDWARE LIST
A x 18
3 in 1 Bolt
B x 18
Excenter Fitting
C x 11
Long Allen Screw
D x 11
Washer
E x 1
Allen Wrench
F x24
Back Panel Screw
G x 16
Shelf Panel Support

4
Step One
-Screw eight 3-in-1 bolts to base panel (1).
-Screw three 3-in-1 bolts to left front panel (4).
-Screw three 3-in-1 bolts to right front panel (5).
-Screw four 3-in-1 bolts to top panel (11)
Step Two
-Join left inside panel (6) with left front panel (4) by inserting three bolts in the holes of (6). Using
three excenter fittings lock the bolts.
-Repeat with right inside panel (7) and right front panel (5).
1
11
4
5
A
A
A
A
4
5
6
7
B

5
Step Three
-Set base panel (1) on a flat surface as shown.
-Join panel (2), (3), (6), (7) by inserting eight bolts in the holes of the four panels. Using eight
excenter fittings lock the bolts.
Step Four
-Attach upper firebox trim (8) to left & right inside panel by securing 2 allen long screws through 2
washers. Tighten all the screws with the allen wrench provided.
-Attach left center panel (9) to left outside panel by securing 1 allen long screw through 1 washer.
Tighten the screw with the allen wrench provided.
-Repeat with right center panel (10).
1
2
6
7
3
B
B
8
9
10
C
D
E

6
Step Five
-Locate top panel (11) to above finished parts.
-Join panel (6), (7) by inserting four bolts in the holes of the two panels. Using four excenter fittings
lock the bolts.
-Join panel (2), (3), (8), (9), (10) by securing 7 allen long screws through 7 washers. Tighten all the
screws with the allen wrench provided.
Step Six
-Attach 2pcs back panel (12) to above finish parts by securing 24 back panel screws.
11
C
D
A
D
C
12
12 F

7
Step Seven
-Insert 4pcs shelf panel supports to the holes of panel (2), (6), (3), (7) respectively. Keep every 2
supports on parallel.
-Put on 4pcs shelf panel (13) on the shelf panel supports.
Care and Cleaning
Dust the mantel periodically.
Using a soft cloth and a wood cleaner, wipe the mantel clean in the direction of the grain to
minimize the appearance of scratches and scuffs in the finish.
Do not use water to clean mantel. Water may cause swelling, warping or stains if allowed to
penetrate the finish of the mantel. Use protective pads or cloths whenever possible.
Avoid placing mantel in rooms with lots of humidity or where humidity could be a problem.
This may cause warping to the mantel.
Avoid direct sunlight if possible to reduce the possibility of bleaching the finish. If direct
sunlight cannot be avoided, the mantel should be placed so that sunlight hits the mantel
evenly so sunlight bleaching is even and consistent.
13
13
13
13
G
G

Foyer Fresno
Modèle # G1200
Foyers au gel combustible et accessoires

2
!!
Utilisation de votre foyer
Avis : Le client assume l’entière responsabilité de sa
sécurité si le produit n’est pas utilisé selon les
recommandations et les instructions du fabricant.
- Le foyer est conçu pour être utilisé à l’intérieur, il n’y a aucun besoin de ventilation.
- Faire preuve de prudence lorsque allumé. Certaines surfaces deviennent extrêmement chaudes lors
de l’utilisation.
- Suivre toutes les instructions incluses avec le gel combustible avant utilisation.
-Avant d’utiliser le foyer, s’assurer d’avoir lu et compris les instructions étapes par étapes.
- Lors de la première utilisation vous pouvez percevoir une légère odeur. Cette odeur est temporaire et
disparaîtra lors de vos utilisations subséquentes.
Bienvenue dans la grande famille des produits de combus-
tible au gel RealFlame. Pour toutes questions, contactez le
service à la clientèle au 1-800-654-1704 ou allez au site
www.REALFLAME.com
1.Cetensemble ne doitêtreutilisé qu’avec le gel combustibleReal Flame. Ne jamaisutiliserd’autres types
degelcombustible ou d’autresmatièresinflammables.
2.Liretoutes les informations contenuessurl’étiquette et toutes lesinstructions avant d’utiliser legel
combustibleRealFlame.
3.S’assurerque le foyeretle gel combustible estsur une surface planeetde niveau. Toujours garderle
foyerstable.
4.Nejamais laisser le feusanssurveillance, surtout avec la présence d’enfantsou d’animaux domestiques.
5.Nedoit pas êtreutilisépar les enfants. Teniréloigner des enfants etdesanimaux domestiques.
6.Prendreles mêmes précautionsquepour n’importe quel feuextérieur.
7.Lorsde l’utilisation, certaines surfacessonttrès chaudes, soyez prudent.
8.Nejamais toucher lesbûches,le contenant de gelcombustible ou aucune surfacemétalliquedurant
l’usageoutout de suiteaprèsavoir éteint le feu. Toutesles composantes peuvent être extrêmement
chaudes. Laisserl’ensemblerefroidir environ 60minutesavant de le manipuler.
9.Nepas faire brûlerplusde trois contenants degel combustible à lafois.
10.Nepas déposer d’objetsdeplus de 15 lb(6,80 kg) sur ledessusdu foyer.
11.Nejamais modifier lefoyer,la chambre de combustionen métal ou l’ensembledebûches.
12.Garderen tout temps lefoyeret les contenants degel combustible loin detoutesmatières inflammables.
13.Nepas entreposer ouutiliserde produits combustibles, devapeurs ou de liquidesinflammablesà
proximitédufoyer ou dugelcombustible.
14.Nepas porter devêtementsamples ou inflammables lorsde l’utilisation du foyer.
15.Nepas déplacer lefoyeralors qu’il est enmarche. Éteindre les contenantsdegel et attendre60minutes
avantdebouger ou d’entreposerlefoyer.
16.Nepas brûler depapiers,de déchets ou debois dans le foyer. Nebrûlerque le gelcombustibleReal
Flame.
17.Nepas brûler legelcombustible en dehors del’endroit désigné sur lagrillede métal.
18.Nepas placer lefoyerdans un endroit oùil y a beaucoupdecirculation (corridor ouentrée).
19.Encas d’urgence, utiliserunextincteur à neige carboniquepour éteindre le feu.
20.Lanégligence à suivrescrupuleusementces instructions peut occasionner desblessures sérieuses, des
dommagesàla propriété etmêmela mort.
21.Sipour toutes raisons,vousne pouvez suivre cesmises en garde, appelez-nous au1-800-654-1704.
Avertissements

3
Liste des pièces
Nº Description Nº de pièce Quantité
1 Panneau de base G1201 1
2 Panneau extérieur gauche G1202 1
3 Panneau extérieur droit G1203 1
4 Panneau avant gauche G1204 1
5 Panneau avant droit G1205 1
6 Panneau intérieur gauche G1206 1
7 Panneau intérieur droit G1207 1
8 Moulure supérieure du foyer G1208 1
9 Panneau central gauche G1209 1
10 Panneau central droit G1210 1
11 Panneau supérieur G1211 1
12 Panneau arrière G1212 2
13 Tablette G1213 4
Liste de quincaillerie
18 x A:
Boulon 3 en 1 18 x B: Écrou de blocage
11 x C:
Vis Allen longue
11 x D:
Rondelle
1 x E:
Clé Allen
24 x F:
Vis pour panneaux arrière
16 x G:
Support à tablette