RealFlame Silverton G8600 User manual

G8600-Silverton-031313JW
Mantel Assembly Instructions
Model # G8600
Silverton Fireplace
Lot:___________
PO:___________

WARNINGS
!!
If you have questions please call customer service at: 1-800-654-1704
Using your
Fireplace
Fireplace is designed to be used indoors.
Before using unit, be sure you have read and understood the step-by-step
instructions in this manual.
After several burns, soot may develop on the inside of the firebox. Clean with a
damp soapy rag.
During the initial burn you may experience a slight odor. Odor is temporary and
will be absent on following burns.
Real Flame® Gel Fuel contains isopropyl alcohol.
Avoid contact with eyes, mucous membranes or prolonged contact with skin. May
irritate eyes. Store in a cool, dry place. Keep away from flame, heat or items that
spark. Use in well-ventilated areas. Keep out of reach of children and pets. In case
of fire, use a CO2 fire extinguisher or baking soda.
GEL FUEL
If fuel gets in eyes, flush with water for 15 minutes; get medical attention. If ingested,
do not induce vomiting; call poison control center or a doctor.
FIRST AID
-
-
-
-
1. Burn only Real Flame ® 13oz Gel Cans in the log set. Only Real Flame ® Gel Cans have been tested and
approved for use in this log set. Never burn any other fuel or trash, paper, or wood.
2. Never alter or dismantle the metal firebox in any manner.
3. Make sure the fireplace is placed on a flat and level surface. Failure to do so could cause the product to tip,
resulting in property damage or serious injury. Do not place the fireplace in an area with lots of traffic, such as
a hallway or entryway.
4. Do not pour or scoop gel out of the can or try to combine gel from different cans.
5. Light Real Flame® gel fuel cans only when placed in the designated areas in firebox. Wipe up spills. Use a long
match or extended butane lighter to ignite fuel.
6.
Do not let anyone below age 18 use this fireplace. Never leave a fire unattended. Keep children and pets away
from a burning unit.
7. Never touch any logs or metal surfaces during or immediately after burning gel fuel. They will be extremely HOT.
Allow surfaces to cool for 20 minutes before touching, changing cans, or moving the unit.
8. Do not wear flammable or loose clothing when operating the fireplace.
Do not lean over the unit when lighting.
9. Do not place more than 100 lbs. of weight on the top of the fireplace at anytime.
10. Exercise the same precautions you would with any open fire.
Users are responsible for following these instructions
and operating this product safely.
Read entire label and all instructions included with gel fuel and fireplace.
PROPERTY DAMAGE, SERIOUS INJURY OR DEATH may result if these warnings are not followed.
Gel Fuel is flammable. Failure to follow warnings can result in property damage or serious burns.
Do not attempt to remove, replace or fill a can while it is burning or still hot. Pouring any kind of fuel on a
fire can result in flare-ups or flashbacks. Make sure the fire is out and allow the can to cool for 20 minutes
before touching it.
Do not store or use gasoline or other flammable materials, including gel fuel, near this product. Vapors or leaks
could travel to sources of flame or heat and increase the risk of fire or explosion.
In case of an emergency use a CO2 extinguisher or baking soda to extinguish the fire.
-
-
-
-
HAZARDS
Real Flame ® fireplaces have been designed and tested for use with Real Flame ® Gel Cans only. Do not use any
other brand of fuel, or flammable materials in the product.
RF Mantle WARNINGS 061913

White
3
PARTS LIST
HARDWARE KIT-86000013
A x 24
Short Allen Screw
B x 12
L-Bracket
C x 22
Long Allen Screw
D x 22
Washer
E x 1
Allen Wrench
F x 2
MDF Board
1
2
3
4
5
6
7
8
9
10
12
11
Number Desc ription Quantity
1 B as e P anel 1
2 Left S ide P anel 1
3 Ri ght S ide P anel 1
4 Left Front P anel 1
5 Ri ght F ront P anel 1
6 C enter P ane l 1
7 T op P ane l 1
8 Left F irebox T rim 1
9 Ri ght F irebox T rim 1
10 Lower F irebox T rim 1
11 Upper F irebox T rim 1
12 F irebox S upport 1
13 Hardware K it 1
Black
86000101JW
86000102JW
86000103JW
86000104JW
86000105JW
86000106JW
86000107JW
86000108JW
86000109JW
86000110JW
86000111JW
86000012JW
Dark Mahogany
86000501JW
86000502JW
86000503JW
86000504JW
86000505JW
86000506JW
86000507JW
86000508JW
86000509JW
86000510JW
86000511JW
86000012JW
86000013JW86000013JW
JW
86000801JW
86000802JW
86000803JW
86000804JW
86000805JW
86000806JW
86000807JW
86000808JW
86000809JW
86000810JW
86000811JW
86000012JW
86000013JW

4
Step One
-Join left side panel(2) with left front panel (4) by securing 6 short allen screws (A) through
3 L-brackets (B).
-Repeat with right side panel(3) and right front panel(5).
Step Two
-Set base panel (1) on a at surface as shown.
-Join panel (2) & (4), (3) & (5) by securing 8 short allen screws (A) through 4 L-brackets (B).
2
45
3
A
A
B
2
45
3
1
A
A
B

5
Step Three
-Attach left rebox trim (8) to left front panel (4) by securing 2 long allen screws (C) through 2
washers (D). Fit on base panel(1) by securing 2 sh ort allen screws (C) through 1 L-bracket (B).
-Repeat with right rebox trim (9).
Step Four
-Attach lower rebox trim (10) to side rebox trim (8) , (9) by securing 2 long allen screws (C)
through 2 washers (D).
-Attach upper rebox trim (11) to front panel (4) , (5) by securing 2 long allen screws (C) through 2
washers (D). Fit on side rebox trim (8) , (9) by securing 4 long allen screws (C) through 4
washers (D) and 2 MDF boards (F).
8
C
89
45
C
D
C
D
9
1
D
A
A
B
45
11
C
D
F
10