8
2.
-
ment located on the base bottom. If necessary use the extender of a suitable
power (no less than 2.5 kW).
3.
4.
may be splashed.In case of water undersupply the appliance may be switched
ATTENTION! The unit is meant only for water heating and boiling.
5.
6. Plug in the kettle.One short audible signal will be heard (if audible signals are
enabled),all the indicators on the panel and display and illumination will be lit
for 1 second.Then the appliance will switch to the standby mode. In the stand-
in the kettle is displayed at the bottom of the display.
To enable/disable audible signals
1. To disable audible signals in the standby mode press «–» button and,holding it,
press
appliance will switch to standby mode.
2. To enable audible signals in the standby mode press «–» button, and, holding
it, press
will be heard,On indicator will appear at the bottom of the display.The appliance
In the description of the operation process of the appliance it is implied that audible
signals are enabled.
The Ready for Sky technology
control the appliance remotely from a smartphone or tablet.
1.
operating system) onto your smartphone or tablet.
2.
appear on the screen.
3.
synchronization starts. An audible signal will be heard. During synchronization
and indicators will be alternately lit up on the top of the display.Then
the appliance will switch to the standby mode after the connection is complete.
If within 10 seconds the connection won‘t be made, the appliance will switch to the
standby mode.
4.
To disable remote control feature press and hold down «-» button in the
standby mode until an audible signal is heard.
To ensure a stable connection, the mobile device should be no more than 10 metres
from the appliance.
Boiling water
1. Press
the bottom of the display.
2.
go out and the appliance will switch to the standby mode.
3. To interrupt the water heating process repress
the base.
Heating water without boiling
not been boiled retains its natural properties, which is particularly important when
brewing premium teas.
-
1. Press .The button indicator will start blinking.The heating process will start,
-
2.
3. After the desired temperature is reached an audible signal will be heard and
button indicator will be lit up solid in this mode.
4.
To interrupt the water heating process repress
the base.
If the temperature in the kettle is higher than the desired heating temperature the
heating process won‘t be enabled.
To switch to the „Heated boiling“ mode during heating process press button.
