REED FPV20 User manual

Instructions for Assembling Field Pipe Vise
1114-50312
Instructions for Assembling the FPV20
1. Cut four pieces of 11/2" (48 mm) diameter pipe, each 40"
(1015 mm) long for the legs and one piece 6 feet (1.83 m) long for
the backbone.
2. Slip the Chain Vise base (center section) on to the backbone,
clamping it on the pipe about 15" (380 mm) from one end by
tightening the two bolts.
3. Next, slip a leg frame over each end of the backbone with the
"window" in each leg socket facing outward. Lay the backbone
on the floor upside down, resting the V's and put a pipe leg in
each socket.
4. Make sure that each pipe leg bottoms in the socket (see window).
Tighten the threaded knob or bolt in each leg frame to
clamp the entire assembly together. It is helpful to
assemble this vise upside down with the V's resting on
the floor; the two leg frames and the pipe clamp then
Capacity 2" - 20" (50 - 500 mm)
Fig. 1
Cat. No. FPV20
Item Code #06027
automatically line up, Fig. 1.
NOTES:
• If the leg angles need a little adjustment once the vise is
upright, slightly loosen the knob (or bolt) and gently lift the backbone
just a bit. Adjust the legs and retighten the knob (or bolt.)
• Both legs must “bottom” in their sockets or the assembly will not be solid.
• 2,000 pound (900 kg) capacity.

Phone: [phone] or 814-452-3691
Fax: [phone] or 814-455-1697
www..reedmfgco.com
Reed Manufacturing Company
1425 West 8th Street
Erie, PA 16502 USA
5. Turn the pipe stand to an upright position and put the feet on
the lower end of the pipe legs, aligning them so they sit flat on
the floor. Clamp them in this position with the set screws;
the pipe stand is now ready for use.
6. For use on extremely soft or muddy ground, the feet may be
placed on a 5foot (1.53 m) piece of plank, front and back and nailed
in position through the nail holes provided in the sockets.
NOTE: Not recommended for greater torque, just stability for
soft ground.
Transporting the FPV20
When the pipe stand has to be knocked down and transported,
merely loosen the knobs (or bolts) and clamp the legs in the frames.
Remove the four legs and place them in the "V"s, securing them to
the rest of the stand with the chain pipe clamp. The entire assem-
bly can now be carried as one compact bundle. Fig. 2.
Instructions for Assembling Field Pipe Vise
Fig. 2
Capacity 2" - 20" (50 - 500 mm)
1114-50312