Regalo 2882 User manual

www.regalo-baby.com
Regalo International, LLC.
3200 Corporate Center Drive, Suite 100 / Burnsville, MN 55306, USA
866.272.5274 (U.S. only) or 952.435.1080
Made in China
Hook On
High Chair
OWNER’S MANUAL MODEL: 2882
• READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE OF CHAIR.
• KEEP INSTRUCTIONS FOR FUTURE USE.

Before Using Product
• READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE OF CHAIR.
• KEEP INSTRUCTIONS FOR FUTURE USE.
• Failure to follow these instructions for the assembly of use of your Hook On
High Chair could result in serious injury or death. The safety of your child is
your responsibility.
WARNING
Failure to follow all warnings and instructions could
result in injury or death.
Fall Hazard. To prevent falls:
•ALWAYS use restraints. Adjust to fit snugly.
• Keep child in view.
• To prevent tipover, check stability of table
before and after seating child.
• NEVER use with:
• glass table top
• single pedestal table
• table leaf
• Child can use nearby supports to kick or push
chair off table or counter. NEVER use hook-on
chair:
• with ordinary chair underneath
• in reach of table legs
• near island below countertop
• loose table top
• card table
• table cloths or place
mats
Use only for:
• child who can sit upright without help.
• child up to 37 pounds (16.8 kg).
• tables 1 to 2 in. thick (25.4 to 50.8 mm).

WARNING
• Discontinue use if hook-on chair is broken. Contact
manufacturer immediately for replacement parts or
service.
• Do not use without all tips (suction cups or other locking/
latching mechanisms) attached securely to table surface.
• Discontinue use if child, when seated in hook-on chair, is
able to move the hook-on chair arms on the table top.
• Do not allow other children to play near or walk under
hook-on chair while in use.
• Before removing child from hook-on chair, be sure child's
legs are free from hook-on chair supports.
• Keep table and seat clean and dry to prevent slipping.
• Hook-on chair should be assembled as close as possible
to the table.

English 5
Before Assembly
D
C
B
A
PLEASE CHECK TO MAKE SUREYOU HAVE THE FOLLOWING PARTS:
A Seat
B U-Bar
C Left Arm
D Right Arm

English6
AssemblingYour High Chair
STEP 1
Remove the black plastic ends from all the metal bars.
STEP 2
Slide the u-bar through the sleeve at the back of the seat support until the ends
are exposed on both sides.
STEP 3
Slide the paddle grip of the right arm through the sleeve on the
right side of the seat.

English 7
STEP 4
Attach the right arm to the right side of the u-bar, pushing the
spring pin, as you slide the arm over the u-bar.
Repeat STEPS 3 – 4 for the left side.

English8
Installing Your High Chair
STEP 1
Slide the high chair onto the edge of a table, making sure that the pegs are
underneath the table and that the grip pads are on top of the table.
Make sure the locks are folded down so that they do not interfere with the
attachment to the table. Press in the lock release button to do this.
STEP 2
Push down on the back of
the high chair until the seat is
almost level with the table top.
NOTE: Your high chair will be noticeably angled when first placed on the table
top. THIS IS NORMAL. Proceed to STEP 2.
PEGS
GRIP PADS
LOCK RELEASE BUTTON
LOCK

English 9
NOTE: If properly locked to the table top, you should not be able to pull your
high chair off the table, even when pulling with a reasonable amount of force.
STEP 3
Pivot the locks back until they automatically
lock in the vertical position.
STEP 4
Continue to push down on the back of the seat while
turning the locking knobs until they are tight against the
bottom of the table surface.

English10
Harness Instructions
STEP 1
To secure your child in the harness, push buckle tongues into buckle housing
and adjust with waist strap adjuster so that the waist strap is firmly secured
around child.
Attach shoulder strap clips in position on buckle tongues. Then adjust so that
they are secure, yet comfortable on child.
WAIST STRAPWAIST STRAP
ADJUSTER
SHOULDER STRAPS
SHOULDER STRAP
ADJUSTERS
CLIPS
BUCKLE HOUSING BUCKLE TONGUEBUCKLE TONGUE