Reiner K1 User manual

www.reiner.de
Award for
Operational
Excellence
Bedienungsanleitung
Operating instructions
Mode d’emploi
Manual de instrucciones
Istruzioni per l’uso
Instruções de utilização
Instrukcja obsługi
Руководствопоэксплуатации
D
GB
F
E
I
P
PL
RUS
K1

Vielen Dank, dass Sie sich für ein Original
REINER Produkt entschieden haben.
Thanks a lot for making your mind for an
original REINER product.
Merci infiniment d’avoir choisi un produit
Original REINER.
Muchas gracias por haberse decidido por
un producto original de REINER.
Vi ringraziamo per aver optato per un
prodotto originale REINER.
Muito obrigado por ter optado por um
produto REINER original.
Dziękujemy Państwu za to, że zdecydowali
sięPaństwo na zakupienie oryginalnego
produktu REINER.

Благодаримзавыбороригинальной
продукцииREINER.
Ernst Reiner GmbH & Co. KG

1
2
3
4
5

GB GB
To set the stamp wheels _Fig. 1+ 2
uPress the handle to the bottom of its
travel, then while still holding it.
uPress bolt at the bottom end of the handle.
uGuide the handle upwards until the handle
snaps into a depression.
uYou will be able to move the stamp wheels
freely with the stylus .
You can lower the preceding zeros!
Example: 49 instead of 000049
uTurn the stamp wheel with stylus to
digit position “0”.
uUsing stylus rotate and push down on
stamp wheel through a half digit position
until it sinks below print height.
uTo return to the print position, simply push
bolt in the middle of the handle .
uAny wheel which has been ‘sunk’ will auto-
matically be brought to print height as the
numbering sequence progresses. ‘Sunk’ wheels
can be brought into play by simply rotating
them further (ie. push towards figure 1.).
To insert the inkpad _Fig. 1+ 3
Handle with caution to avoid dirt from ink!
uPress the handle to the bottom of its
travel, then, while still holding it.
uPress the button on the front plate and
continue to hold it.
uAllow the handle to move upwards until the
handle locks in place.
uUnpack the inkpad carefully.
uInsert the inkpad in the slot of the stamp
up to the limit stop and fasten with the
screws of the inkpad.
uResting the back of the ink pad inside the
pad cradle slide the pad into the slot of
the stamp.
uIn order to return to the starting position,
hold handle and push bolt in the middle.
To change the numbering actions _Fig. 4
Actions
0The same number is stamped every time.
1Number increases after each stamping
process.
2Number increases after every 2nd
stamping process.
etc.
uLoosen the screw .
uRaise the automatic and place the slide
at the desired interval.
uTighten the screw .
To park the stamp _Fig. 5
To prolong the life of the inkpad,
park the stamp!
uPress the bolt at the bottom end of the
handle and then keep pressing it.
uGently push handle downwards until the
stamp clicks & locks in a raised position.
uTo return to the starting position, hold
handle and push bolt in the middle.
A
A
A
A
A
A
A
A
B
B
B
C
C
D
D
E
G
F
F
H
B
B
B
C
D
E