5. Put the assembled step 4 flush on ground as shown below，take two
glass doors, put the first glass onto the inner rail, and then put the second
glass onto the outer rail
6. Take Accessories F (Glass Lock*1pcs), unscrew it ,clip it into the inner
rail glass and then tighten it with a screwdriver.Glue Accessories D(Door
Handles*2pcs) and Accessories E(3M Sticker*2pcs) together and stick it to
the glass door of the outer rail according to personal preference
Installation Instructions
1. Take Accessories A (Lock Lever* 9pcs ), screw them separately into holes
of ①Back Board and ③Bottom Bar and tighten them to ②Bottom Board
with Accessories B (Lock Catch*6 pcs)
Note: The arrow direction of all accessories' lock catch must be aligned with
the direction of the accessories' locking lever before they can be put in
(tighten in the+direction and unscrew in the - direction)
2. Take Accessories A (Lock Lever* 3pcs ), screw them separately into holes
of ④Upper Bar and tighten them to ⑤Mesh Cover with Accessories B
(Lock Catch* 3pcs)
Note: The arrow direction of all accessories' lock catch must be aligned with
the direction of the accessories' locking lever before they can be put in
(tighten in the+direction and unscrew in the - direction)
3. Place the installed steps 1 and 2 vertically on the ground, and lock them
with Accessories B (Lock Catch * 3pcs) as shown in the figure
Note: The arrow direction of all accessories' lock catch must be aligned with
the direction of the accessories' locking lever before they can be put in
(tighten in the+direction and unscrew in the - direction)
4. Take Accessories A (Lock Lever* 20pcs ), screw them separately into holes
of⑥(Right Side Board）and ⑦（Left Side Board), first install steps 3 with
⑥(Right Side Board) and then tighten with ⑦（Left Side Board）by using
Accessories B (Lock Catch * 20pcs), and place Accessories C (Cable Pass
*1pcs )in the right position
Note: The arrow direction of all accessories' lock catch must be aligned with
the direction of the accessories' locking lever before they can be put in
(tighten in the+direction and unscrew in the - direction)
Outer Rail Door
Inner Rail Door
Inner Rail Door
Outer Rail Door
The key can be removed
F
