ReSound LiNX3D 67 User manual

Quick guide
ReSound LiNX 3D™ 67

My hearing aid information
Product: ReSound LiNX 3D
Model: 67
Serial Number (R):
_____________________________
Serial Number (L):
_____________________________
Battery Size: 312

Push Button:
(if set up by your hearing care professional)
ACTION RESULT
Short Push
Long Push
PROGRAM WHEN TO USE BEEPS
11
22
33
44
Programs:
(if set up by your hearing care professional)

Get to know your hearing aid
A. Program button
B. Microphones
C. Programming port for
cabled fitting
D. Battery Door
E
A
C
B
View ReSound hearing aid tutorial videos at youtube.com/resoundus
E. Right/Left indicator
F. Thin tube
G. Dome
D
6
1
5
4
3
2
8/9
10
7
8/9
11
12
13
14
18.c
18.b
9
1. Program button
2. Battery compartment & On/Off switch
3. Sound outlet
4. Front microphone inlet
5. Back microphone inlet
6. Volume control (optional)
7. Direct audio input
8. Left/Right indicator (Left=Blue/Right=Red)
9. Battery lock (optional)
10. Model
11. Manufacturer
12. Serial number
13. LED indicator (optional)
14. Battery lock release (optional)
15. Earhook
16. Earmold and tubing
17. Thin Tube
18. Domes/earmold
a. Open dome
b. Tulip-Dome
c. Custom earmold
19. Sports lock (optional)
400144011-US-13.09-Rev.E.indd 9 25-09-2013 14:42:17
Open fitting
(Thin Tube and dome)
F
G

Getting Started: On/O function
ON: Insert battery & completely close
battery door (D). Program 1 will
be active.
OFF: Open the battery door (D). Use
fingertip to pull it all the way.
What you need to know
OFF
ON
Inserting/Replacing the battery:
1. Open the battery
door (D)
completely by
using your fingertip.
2. Remove protective sticker from
battery and wait 2 minutes
before
inserting the
battery into the
hearing aid to
allow full activation of the battery.
3. Insert the new battery with the
positive side (flat side) in the
correct position, as shown above.
4. Gently close the battery door. If it
doesn’t close easily, check to see
if the battery is upside down.

Daily: Clean your hearing aid.
Keep your hearing aids dry. Clean
the hearing aids using a soft cloth
or tissue.
Weekly: Clean the thin tubes and
domes/earmold.
1. Remove thin tubes (F) from hearing
aids before cleaning by unscrewing
them counter clockwise.
2. Wipe down thin tubes and domes (G)
with a soft cloth.
3. In order to clear the thin tube of
moisture and debris, push the black
cleaning rod through the thin tube,
beginning at the end opposite
the dome.
Regular care & maintenance
12
30
How to apply domes
It is recommended that your hearing care
professional change domes, as incorrect
dome replacement could result in injury.
ReSound standard domes
1. Push the new dome over the receiver.
2. Make sure that the new dome is
properly and securely mounted.
ReSound tulip domes
Tulip domes are mounted in a similar manner to standard domes, but a few extra steps are required. Tulip
domes consist of two “petals”. It is important to note that the largest petal is the outermost petal. To ensure
this:
1. Push the largest petal away from
the receiver tube using a finger. This
bends the petal forward.
2. Then push the largest “petal” back,
and it will be placed on top of the
smaller petal.
400344011-US-15.04-Rev.B.indd 30 20-05-2015 11:48:59
As needed: Change dome (G)
(if applicable)
ReSound standard domes
1. Push the new dome on to the
thin tube.
2. Make sure that the new dome is
properly and securely maintained.
ReSound tulip domes
Tulip domes consist of two “petals”. It
is important that the largest petal is
the outermost petal. To ensure this:
1. Push the largest petal away from
the thin tube using a finger.
This bends the petal forward.
2. Then push the largest “petal”
back, and it will be placed on top
of the smaller petal.
12
30
How to apply domes
It is recommended that your hearing care
professional change domes, as incorrect
dome replacement could result in injury.
ReSound standard domes
1. Push the new dome over the receiver.
2. Make sure that the new dome is
properly and securely mounted.
ReSound tulip domes
Tulip domes are mounted in a similar manner to standard domes, but a few extra steps are required. Tulip
domes consist of two “petals”. It is important to note that the largest petal is the outermost petal. To ensure
this:
1. Push the largest petal away from
the receiver tube using a finger. This
bends the petal forward.
2. Then push the largest “petal” back,
and it will be placed on top of the
smaller petal.
400344011-US-15.04-Rev.B.indd 30 20-05-2015 11:48:59

Flight Mode:
Some airlines prohibit the use
of wireless hearing aids (RF
transmitters) onboard. If required
by your airline, enable flight mode:
Disable wireless operation by opening
and closing the battery door (D)
three times within ten seconds
(open-close, open-close, open-close).
Your instruments will now be in
flight mode.
The hearing aids must function in
flight mode for 10 seconds before
wireless operation can be re-enabled.
To re-enable wireless operation,
open and close the battery door one
time and wait thirty seconds before
opening the battery door again to
avoid accidentally entering flight
mode again.
For more information
400708011 Rev A 2017.02
Refer to the user guide included in
your hearing aid box.
Your hearing care professional can
be reached at:
View ReSound hearing aid tutorial
videos at youtube.com/resoundus.
ReSound Government Services
8001 E. Bloomington Freeway
Bloomington, MN 55420
1-800-392-9932
www.resound.com/veterans
Manufacturer according
to FDA:
ReSound North America
8001 E. Bloomington Freeway
Bloomington, MN 55420
1-888-735-4327
resound.com
Manufacturer according
to Health Canada:
ReSound Canada
303 Supertest Road
Toronto, Ontario M3J 2M4
1-888-737-6863
resound.com

Beep/tone indicators
View ReSound hearing aid tutorial videos at youtube.com/resoundus
BEEP/TONE INDICATION ACTION REQUIRED
Ding, ding, ding,
dong
Low battery Change battery
Ding (5 or 10) Hearing aid is starting up After dings cease, hearing
aid is turned on
Ding-ding,
ding-ding, etc.
Hearing aid is in flight
mode
Use in flight mode if
desired, or open-close
battery door to exit
flight mode
Ripple Tone Hearing aid is in
streaming mode
Use with wireless
accessory or press
multi-function button
to exit streaming mode

Troubleshooting
SYMPTOM CAUSE POSSIBLE REMEDY
No Sound Battery door not closed
Dead battery
Battery door will not close
Blocked earmold or tube
Blocked wax filter
Turn on by closing the battery door (D)
Replace battery
Insert battery properly
Clean earmold or tube (F)
Replace wax filter or consult your
hearing care professional
Not loud enough Blocked earmold or dome
Change in hearing, volume too low
Excessive ear wax
Clean earmold, replace dome (G)
Consult your hearing care professional
Consult your hearing care professional
Excessive
whistling/feedback
Incorrect earmold placement
Incorrect dome placement
Excessive ear wax
If none of the above
Re-insert earmold carefully
Re-insert dome (G)
Clean guard/consult your hearing care professional
Consult your hearing care professional
Wireless does not work Device may be in flight mode Open and close the battery compartment once.
Wireless operation will reactivate ten seconds
later.
If there are any other problems not mentioned in this guide, please contact ReSound or your hearing care professional.