Respironics DreamStation Series User manual

Respironics DreamStation Series: Single Battery Connection
BATTERY POWER SOLUTIONS
Page 1 of 2 June 2016

DC OUT JACK

12V POWER
ADAPTER
PAP DC
INPUT PORT

The DC input port on Respironics DreamStation series devices require a proprietary signal in order to recognize a
valid power source; therefore, the use of a 12V power adapter is required in conjunction with the FreedomTM CPAP
Battery. Our 12V power adapter was designed specifically for use with Respironics DreamStation series devices and
the FreedomTM CPAP Battery.
REQUIRED COMPONENTS
FreedomTM CPAP Battery Kit
DreamStation 12V Power Adapter
CONNECTION INSTRUCTIONS
Plug the 12V power adapter into the DC OUT jack of the battery.
Plug the 12V power adapter into the DC input port of the PAP device.
Turn the PAP device on and it should begin functioning.
The digital display screen will show the charge level of the battery. You may press the charge level indicator
button to illuminate this screen. It will stay illuminated for a few seconds at a time.
When not in use disconnect all devices from the battery thus allowing the battery to completely shut down.
OPTIONAL FREEDOMTM CPAP BATTERY CHARGING ACCESSORIES


Auto Charge DC Cable {BPS DC.CABLE}: Used to charge the battery in a vehicle (vehicle must be running).


150W Sine Wave Power Inverter {BPS 150 INVERTER}: Used to charge the battery in a vehicle (vehicle does not need to
be running) and allows the battery to power/charge other small electronic devices.


SunPower 40W Solar Panel {BPS SP40}: Used to charge the battery using the power of the sun.

BATTERY POWER SOLUTIONS
Page 2 of 2 June 2016
Respironics DreamStation Series: Dual Battery Connection

DC OUT JACKS

12V POWER ADAPTER


DC POWER PIGTAIL CORD
PAP DC
INPUT PORT
The DC input port on Respironics DreamStation series devices require a proprietary signal in order to recognize a
valid power source; therefore, the use of a 12V power adapter is required in conjunction with the FreedomTM CPAP
Battery. Our 12V power adapter was designed specifically for use with Respironics DreamStation series devices and
the FreedomTM CPAP Battery.
REQUIRED COMPONENTS
FreedomTM CPAP Battery Kit
FreedomTM CPAP Battery (additional battery only)
DreamStation 12V Power Adapter
CONNECTION INSTRUCTIONS
Plug the 12V power adapter into the DC power pigtail cord.
Plug the DC power pigtail cord into the DC OUT jacks of both batteries.
Plug the 12V power adapter into the DC input port of the PAP device.
Turn the PAP device on and it should begin functioning.
The digital display screen will show the charge level of the battery. You may press the charge level indicator
button to illuminate this screen. It will stay illuminated for a few seconds at a time.
When not in use disconnect all devices from the battery thus allowing the battery to completely shut down.
OPTIONAL FREEDOMTM CPAP BATTERY CHARGING ACCESSORIES


Auto Charge DC Cable {BPS DC.CABLE}: Used to charge the battery in a vehicle (vehicle must be running).


150W Sine Wave Power Inverter {BPS 150 INVERTER}: Used to charge the battery in a vehicle (vehicle does not need to
be running) and allows the battery to power/charge other small electronic devices.


SunPower 40W Solar Panel {BPS SP40}: Used to charge the battery using the power of the sun.