Rexing V1PGW-4K User manual

User Manual
V1PGW-4K
The information in this manual is subject to change without notice.
Rexing All Rights Reserved
www.rexingusa.com

We hope you love your new products as much as we do. If you need any
assistance, or have any suggestions to help us improve, please contact us.
Our support team will respond to you as soon as possible.
Always a surprise in Rexing.
•https://www.facebook.com/rexingusa/
•https://www.instagram.com/rexingdashcam/
•https://www.rexingusa.com/support/registration/
•https://www.rexingusa.com/support/product-support/
1
About Us
Thank you for choosing REXING!
Check us out here
Facebook Instagram Site Product Support
[email protected]
[phone]

User Manual
Theinformation in this manual is subject to change without notice.
RexingAll Rights Reserved
www.rexingusa.com
Package Contents
1. Rexing V1PGW-4K Dash Cam
2. Rear camera with rear camera cable
3. Mini-USB Cable
4. Mount Plate & 3M Adhesive
5. Cable Clips
6. Car Charger
7. Cable Management Tool
8. Safety Guide
9. User Manual
65
123
4 7 98
2
Safety Guide
安全ガイドwww.rexingusa.com
Double Coated Tissue
Double Coated Tissue
REC MIC
OK
V1PGW-4K

Camera Overview
3
1. Micro SD Card Slot
2. Power Button
3. Reset Button
4. Menu Button
5. Mode Button
6. REC (Record) Button
USB
10
12
11
m
1
2
3
4
REC MIC
OK
5 6 7 8 9
7. OK (Confirm) Button
8. MIC (Microphone) Button
9. Screen Button
10. Mini-USB Power Port
11. Rear Camera Port
12. Lens Angle Adjustment Dial

4
1. Recording Mode
2. Recording (On)
3. WDR Mode (On)
4. G-Sensor Sensitivity Level
5. Recording Time (Current Clip)
6. Video Resolution
7. Parking Mode (On)***
8. GPS Signal (not connected)
9. Memory Card (Inserted)
10. Time (24H)
11. Current Date Time
12. MIC (Off)
13. Exposure Value
14. Loop Recording Time Interval
15. GPS Signal (connected)
16. Battery Charging
17. Plate Number
18. MIC (On)
*** Please connect a Smart Hardwire Kit or an Intelligent Hardwire Kit to activate the parking
monitor feature.
WDR
UHD P24+FHDP24
00:00:20
04 / 10 / 2021 17 : 25 : 45
AAAAAAAA
WDR
UHD P24+FHDP24
00:00:20
04 / 10 / 2021 17 : 25 : 45
AAAAAAAA
1 2 4 53
11 10
14
13
12
18 17 16
15
7
8
9
6

Get Started
5
Step 1
Installing Adhesive Mount
Place the 3M adhesive on the mount plate and properly orient the mount piece to
the roof and hood line of the vehicle.
Important! Ensure the T-interlock on the mount is oriented in the correct direction.
Firmly press the mount onto the windshield. Wait at least 20 minutes before
mounting the camera.
Orient the mount as shown

6
Step 2
Mount the Rear Camera
Mount the rear camera as shown below. Use the included rear camera cable to
connect the rear camera to the front camera.
Plug the rear
camera into the
rear camera port
Rear camera
wiring
instructions
REC MIC
OK

7
Step 3
Insert the Memory Card
The Rexing V1PGW-4K accepts Class 10/ UHS-1 or higher Micro SD memory cards
up to 256GB. You will need to insert a memory card before recording. Before
inserting or removing a memory card, ensure you've powered down the device.
Gently push the memory card in until you hear a click, and allow the spring release
to push the card out.
Press the POWER
button for about 3
seconds to turn
the power off first
REC MIC
OK

8
Step 4
Power on the Camera and Format the Memory Card
Place the camera on the mount and carefully route the power cable around the
windshield and tuck it in under the trim.
Power the camera by connecting the charger to the car cigarette lighter and the
camera.
To ensure the V1PGW-4K records to your memory card properly and without error,
we strongly recommend you to format the card within the camera when you're
using the dash cam for the first time.
Note:
Always remember backup important data stored on the memory card before
formatting.
The camera will shut down after 3 seconds when it's disconnect from the power
source and it should begin recording automatically the next time it is powered on.
Plug the mini
USB connector
to the dash cam
Route the
power cable
Plug the charger
into the power
outlet or a
cigarette lighter
REC MIC
OK
REC MIC
OK

9
All data will be
deleted
Cancel
OK
Press the
MENU
button twice
Press the OK
button to confirm
formatting the
memory card
REC MIC
OK
V.1.0
LCD
Setup
3/3
Screen Saver
Default Setting
Version
F
Format
To format the memory card, first press the REC button to stop recording. Then
press the MENU button twice to enter the Setup Settings. Use the REC and MIC
buttons and toggle to the Format. Press the OK button to confirm the format.