RH ASTON QUEEN BED User manual

CARE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
PARTS INCLUDED HARDWARE INCLUDED
ASSEMBLY INSTRUCTIONS
1. Dust often using a clean, soft, dry and lint-free cloth.
2. Blot spills immediately and wipe with a clean, damp cloth.
3. We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
1. Please read all instructions carefully before assembling.
2. For your safety, assembly by two or more adults is strongly recommended.
3. Keep these instructions for future use.
4. Use only vendor-supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural integrity of the item.
A
B
C
D
E
[1]
[2]
[1]
[13]
[1]
HEADBOARD
SIDE RAILS
FOOTBOARD
BED SLATS
SUPPORT SLAT
Allen bolt
Lock washer
Flat washer
Allen wrench
16 pcs.
16 pcs.
16 pcs.
1 pc.
1. Place the headboard (A) and footboard (C) upright in the location you wish the bed to be in when fully assembled.
2. Align and insert the side rails (B) to the headboard and the footboard. Attach the side rails to the headboard and footboard by
using Allen bolts (1), lock washers (2) and flat washers (3). See FIGURE 1.
Page 1 of 3
FIGURE 1
ASTON QUEEN BED WITH FOOTBOARD INSTRUCTIONS
1
2
3
4
NO. ITEM DESCRIPTION QTY.
10/1/18

Aston Queen Bed - Page 2 of 3
3.
4.
On the inside of both headboard and footboard are pre-installed wooden brackets for
the support slat (E). Set the support slat on the wood bracket, as shown in FIGURE 2.
On the inside surface of both side rails are cavities designed to hold the individual bed
slats (D). Set individual slats on both sides of the rails, as shown in FIGURE 3.
FIGURE 2
FIGURE 3
10/1/18
ASTON QUEEN BED WITH FOOTBOARD INSTRUCTIONS

Aston Queen Bed - Page 3 of 3
SET UP THE HEIGHT OF THE MATTRESS
NOTE: Before starting this step, securely remove all slats and support slat from the assembled bed.
•For the default setting, the slat support rail will be attached to the lower setting on the side rail. If you want to attach the support rail to
the higher setting, please unscrew all bolts and move the support rail to the top setting on side rails. Re-install the bolts and slat
support rail to secure to the side rail. Refer to FIGURE 4A - 4B.
•Repeat the previous step for the wood brackets at front of headboard and back of footboard. Refer to FIGURE 5A - 5B.
FIGURE 4B
FIGURE 4A
FIGURE 5B
FIGURE 5A
10/1/18
ASTON QUEEN BED WITH FOOTBOARD INSTRUCTIONS