RH LUCIDA COFFEE TABLE User manual

LUCIDA COFFEE TABLE INSTRUCTIONS
Thank you for choosing this quality product. Be sure to check all packaging materials carefully for small parts that may
have become loose during shipment and place all parts on a non-abrasive surface.
! WARNING: Table parts can be cumbersome and heavy; therefore, the assistance of two or more
people is recommended in order to prevent personal injury and ensure the table is not damaged during the
assembly process.
PARTS INCLUDED
A [1] GLASS TOP
B [2] LEG FRAMES
HARDWARE INCLUDED
Page 1 of 2
FIGURE 01
NO. ITEM DESCRIPTION QTY.
1Headless Socket Screw Bolt 4 PCS
2Silicon Washer 4PCS
3Metal Washer 8PCS
4Allen Wrench 2PCS
ASSEMBLY INSTRUCTIONS
11/1/18
METAL
WASHER
SILICON
WASHER
1. A work bench or small, sturdy table is
required for assembly. Place the glass top
(A) onto the work bench or table. Ensure the
ends of the glass overhang the bench.
2. In the hardware pack, locate the metal
washers (3) and silicon washers (2). Place
them in the cavities of the leg frames, as
shown in Figure 01.
3. Gently slide the cavity of the leg frames (B)
onto both ends of the glass top up to the
end of the protective film, as shown in
Figure 01.
4. After inserting the leg frames, remove the
coffee table from the work bench and set it
on the floor. IMPORTANT: Four or more
people are recommended when lifting the
coffee table.

FIGURE 02
FIGURE 03
FIGURE 03-A FIGURE 03-B
SILICON
WASHER
HEADLESS
SOCKET
SCREW
BOLT
Lucida Coffee Table - Page 2 of 2
11/1/18
Insert the remaining silicon washers between
the glass top and the leg frames, as shown in
Figure 02.
To keep the table from wobbling, insert the
headless socket screw bolt (1) into the cavities
underneath the leg frames. Tighten all the bolts
with the Allen wrench (4) to a snug fit, as shown
in Figure 03-A.
Place the coffee table in the desired location
and check whether leveling is necessary. If so,
slightly tilt the table and turn the levelers
clockwise to raise and counterclockwise to
lower, as shown in Figure 03-B. Repeat
adjustment procedures if necessary after the
furniture settles on rugs or on carpeted surface.
5.
6.
7.