CGR-630_Operators Manual_CHGR-4815-LA_Rev A_111423.docx
11/14/2023 4:55 PM 3 of 4
WARNING AND SAFETY NOTES:
•Battery manufacturers recommend NEW batteries to CHARGE THE BATTERY FIRST BEFORE DRIVING IT. It
takes 2-3 discharge/recharge cycles to balance a NEW battery.
•Never leave the charger unattended when it is connected to its power supply.
•The allowable AC input voltage is 100-240VAC, 50/60Hz. Never connect it to any other voltage.
•Never place the charger and batteries connected to it on any form of flammable surface.
•Never operate the charger in the vicinity of flammable material or gas.
•Do not submerge the charger in liquids.
•Ensure that there is unrestricted airflow to and from the charger's cooling slots. Never place the charger on a
carpet or similar surface.
•Do not overload AC circuits, the charger may need a full 15amp circuit.
•Do not short circuit the terminals.
•Take great care to maintain correct battery polarity. (STICKER ON UNIT HAS WIRE COLOR AND POLARITY)
•Read the battery manufacturer's instructions and adhere to them strictly.
PROP 65:
Recycle Electronic Component
65 WARNING
WARNING: This product contains chemicals known to
the state of California to cause cancer or birth defects
or other reproductive harm.
For more information: www.P65Warnings.ca.gov
