Side frame
Backrest
Bucket
Support
PARTS DIAGRAM
ASSEMBLY INSTRUCTIONS
OPERATING INSTRUCTIONS
SAFETY PRECAUTIONS
WARRANTY
2 3
To Set Up Commode Frame
1. Unfold frame. Make sure sides of frame are at right angles to the rear of the
frame and the open ends (of cross brace sockets) are facing center of frame.
2. Swing the bucket support frame up and insert the ends of cross brace into the
cross brace sockets on each side frame by depressing the push pins until they
click securely into place.
3. Insert the back brace into back of frame. Ensure push pins click securely into
place.
4. Attach commode seat and lid to rear of frame by pressing clips onto rear cross
brace until they snap securely in place.
> If you do not understand these instructions, contact your dealer or a healthcare professional for
assistance.
> If any parts are damaged or missing, contact your dealer for replacement. Do not substitute parts.
> Ensure commode seat is securely attached to the frame and all legs are set at the same height
before use.
> Users with limited physical strength will require assistance/supervision.
> Weight capacity is 300 lb, evenly distributed.
Rhythm Healthcare, LLC is not liable for personal injury or property damage due to failure to follow
the instructions or recommendations in this manual or improper use of this product.
To Adjust Legs
Using as Bedside Commode
Using Commode as Toilet
Depress the push pin and slide the lower leg up or down to desired height until push pin
clicks into place.
Repeat step 1 for each leg, ensuring they are set at same height.
Lift commode seat and place bucket on support rails, making sure it is directly below the
opening. Lower seat for use.
When not in use (to contain the odor), place the lid on the bucket and use handle on bucket
for cleaning.
Adjust height, if necessary, and remove the back brace. Then replace bucket with splash guard.
Lift toilet bowl seat and place commode over toilet, center the splash guard directly over the
toilet bowl. Lower commode seat for use.
If Commode Seat has been exposed to cold, allow it to reach room temperature before
assembly to prevent cracking. Please read and understand manual prior to assembly
and save for future use.
> Clean after each use with disinfectant.
> Do NOT use organic solvents, such as acetone or abrasive cleaners.
> Inspect weekly for wear and to ensure all components are secure. If any component appears worn
or is not working properly, contact your dealer for repair and/or replacement parts.
MAINTENANCE
Limited Lifetime Warranty against manufacturing defects.
This warranty does not cover product failure due to misuse, negligence, improper storage or handling,
improper operation or unauthorized modifications. This warranty does not extend to non-durable
components which are subject to normal wear and tear and need periodic replacement.
For Warranty Service, it is recommended, but not required that the product be returned to the Rhythm
Healthcare, LLC dealer through whom it was originally purchased. However, all Rhythm Healthcare, LLC
dealers are qualified to assist you in obtaining warranty service. If the product is to be returned to Rhythm
Healthcare, LLC, prior authorization is to be required. In the event of a defect covered by this Warranty,
Rhythm Healthcare, LLC will determined if the product will be repaired or replaced. Rhythm Healthcare, LLC
products are identified by a serial or a lot number label at the time of the manufacture. Removing or
defacing the label may void this warranty. If you have questions about your Rhythm Healthcare, LLC product
Side frame
Commode seat
