Riverbed SteelConnect SDI-130 User manual

STEELCONNECT TM
GATEWAY
LET'S GET STARTED…

1. POSITION THE DEVICE
You can mount the Gateway SDI-130 to a wall using the attached snap disk.
Position cables facing down.If a solid mount is not required, you can use the
SDI-130 as a desktop unit. The gateway ships with the rack mount hardware.
2. CONNECT THE POWER
Provide the SDI-130 with power using a 12 V, 2 A power supply.
3. CONNECT TO THE NETWORK
Connect the SDI-130 to your local network using WAN1 or WAN2.
To find a SteelConnect Manager instance, the SDI-130 requires Internet access;make
sure the network provides a DHCP service so the appliance can establish
a connection automatically.
Need help?
Riverbed Technology | 680 Folsom Street | San Francisco, CA 94107
[email protected] | [phone] | www.riverbed.com
WEEE-Reg.-Nr. DE 36272080
LED LIGHTS
Green: Power
LEDs turn off as soon as the SDI-130 enters normal operation mode.
FACTORY RESET
To reset the SDI-130 to its factory state, press the reset button on the back of the
appliance for 10 seconds. After releasing the button,all five LEDs flash and the SDI-130
resets to the factory default state.
For more information, go to https://support.riverbed.com.
Part Number 712-00284-01