RODE Microphones VideoMic GO Operating instructions

TROUBLE-SHOOTING
What cameras don't support the VideoMic GO?-
The VideoMic GO is extremely user-friendly as there's no switches or
battery to worry about - just plug in and go. All microphones need power
however, and in the case of the VideoMic GO it is drawing a very small
voltage commonly referred to as "plug-in power" from your camera (or
recording device) via the audio cable.
Plug-in power has long been a standard for camera manufacturers, and so
the VideoMic GO is compatible with the vast majority of cameras in the
market.
While this is by no means a complete list, following is a list of cameras that
we can confirm do not support the VideoMic GO. Please refer to the
specifications of your particular camera for information on whether it
supplies power via the microphone jack.
If you are experiencing issues getting your VideoMic GO to operate with a
camera not listed above, firstly be sure to update your camera's firmware
to the latest version (available from your camera manufacturer's website).
If you are still experiencing issues please get in touch with us via our
support page.
Will my RØDE VideoMic fit into the hot shoe mount of my camera?-
The RØDE cold shoe adaptor is a standard size adaptor, also known as a
universal shoe mount. This standard shoe is suitable for the majority of
camera attachments.

If your camera has a different, or custom adaptor, please contact your
camera manufacturer for information on converters to fit the universal
shoe connection.
Why do I get a low level noise sound when recording on my camera?-
This is usually caused by the function of "Automatic Gain Control" or "AGC"
on the camera.
Basically, when the camera cannot sense an audio input signal it
automatically increases the gain of the input. It is increased so much that
the noise floor in the camera microphone amplifier becomes audible .
The AGC can be disabled on some cameras and it is worth checking with
you camera manufacturer for information on this, which can sometimes
require a firmware update to the camera.
RØDE have created the VideoMic Pro to help combat this issue, the
VideoMic Pro contains a 20dB pre amplifier, boosting the mic signal so that
the camera will see a good signal level and not engage its AGC.
We recommend setting your audio levels manually to achieve an optimum
signal to noise ratio and disabling the AGC of the camera.
Will the VideoMic range microphones connect to a tripod?-
Yes, all of our microphones in the VideoMic range have a standard 3/8
thread built into the bottom of the cold shoe mount for connection to a
boompole, mic stand or tripod.