
USING THE UNIT SAFELY
IMPORTANT NOTES
 WARNING
Concerning the Auto O function
The power to this unit will be turned 
o automatically after a predetermined 
amount of time has passed since it 
was last used for playing music, or 
its buttons or controls were operated (Auto O 
function). If you do not want the power to be 
turned o automatically, disengage the Auto O 
function (p. 3).
Use only the stand that is recommended
This unit should be used only with a 
stand that is recommended by Roland.
Do not place in a location that is unstable
When using the unit with a stand 
recommended by Roland, the stand 
must be carefully placed so it is level 
and sure to remain stable. If not using a 
stand, you still need to make sure that any location 
you choose for placing the unit provides a level 
surface that will properly support the unit, and 
keep it from wobbling.
 WARNING
Precautions regarding placement of this unit on a 
stand
Be sure to follow the instructions in the 
Owner’s Manual carefully when placing 
this unit on a stand (p. 2).
If it is not set up properly, you risk 
creating an unstable situation which could lead 
to the unit falling or the stand toppling, and may 
result in injury.
Use only the supplied AC adaptor and the correct 
voltage
Be sure to use only the AC adaptor 
supplied with the unit. Also, make 
sure the line voltage at the installation 
matches the input voltage specied on 
the AC adaptor’s body. Other AC adaptors may use 
a dierent polarity, or be designed for a dierent 
voltage, so their use could result in damage, 
malfunction, or electric shock.
Use only the supplied power cord
Use only the attached power cord. Also, 
the supplied power cord must not be 
used with any other device.
 CAUTION
Use only the specied stand(s)
This unit is designed to be used in 
combination with specic stands 
(KSCFP10, KS-12) manufactured by 
Roland. If used in combination with 
other stands, you risk sustaining injuries as the 
result of this product dropping down or toppling 
over due to a lack of stability.
Evaluate safety issues before using stands
Even if you observe the cautions given 
in the owner’s manual, certain types 
of handling may allow this product to 
fall from the stand, or cause the stand 
to overturn. Please be mindful of any safety issues 
before using this product.
Cautions when moving this unit
If you need to move the instrument, 
take note of the precautions listed 
below. At least two persons are required 
to safely lift and move the unit. It should 
be handled carefully, all the while keeping it level. 
Make sure to have a rm grip, to protect yourself 
from injury and the instrument from damage.
• Check to make sure the screws securing the 
unit to the stand have not become loose. Fasten 
them again securely whenever you notice any 
loosening.
• Disconnect the power cord.
• Disconnect all cords coming from external 
devices.
• Remove the music rest.
Placement
• Do not allow objects to remain on top of the 
keyboard. This can be the cause of malfunction, 
such as keys ceasing to produce sound.
• Depending on the material and temperature 
of the surface on which you place the unit, its 
rubber feet may discolor or mar the surface. 
Care of the Keyboard
• Do not write on the keyboard with any pen or 
other implement, and do not stamp or place any 
marking on the instrument. Ink will seep into the 
surface lines and become unremovable.
• Do not ax stickers on the keyboard. You 
may be unable to remove stickers that use 
strong adhesives, and the adhesive may cause 
discoloration.
• To remove stubborn dirt, use a commercially 
available keyboard cleaner that does not contain 
abrasives. Start by wiping lightly. If the dirt does 
not come o, wipe using gradually increasing 
amounts of pressure while taking care not to 
scratch the keys.
Repairs and Data
• Before sending the unit away for repairs, be 
sure to make a backup of the data stored 
within it; or you may prefer to write down the 
needed information. Although we will do our 
utmost to preserve the data stored in your 
unit when we carry out repairs, in some cases, 
such as when the memory section is physically 
damaged, restoration of the stored content 
may be impossible. Roland assumes no liability 
concerning the restoration of any stored content 
that has been lost.
Additional Precautions
• Any data stored within the unit can be lost as the 
result of equipment failure, incorrect operation, 
etc.
• Roland assumes no liability concerning the 
restoration of any stored content that has been 
lost.
• The sound of keys being struck and vibrations 
produced by playing an instrument can be 
transmitted through a oor or wall to an 
unexpected extent. Please take care not to cause 
annoyance to others nearby.
• Do not apply undue force to the music stand 
while it is in use.
Caution Regarding Radio Frequency Emissions
• The following actions may subject you to penalty 
of law.
• Disassembling or modifying this device.
• Removing the certication label axed to the 
back of this device.
Intellectual Property Right
• It is forbidden by law to make an audio 
recording, video recording, copy or revision of 
a third party’s copyrighted work (musical work, 
video work, broadcast, live performance, or 
other work), whether in whole or in part, and 
distribute, sell, lease, perform or broadcast it 
without the permission of the copyright owner.
• Do not use this product for purposes that could 
infringe on a copyright held by a third party. We 
assume no responsibility whatsoever with regard 
to any infringements of third-party copyrights 
arising through your use of this product.
• The copyright of content in this product 
(the sound waveform data, style data, 
accompaniment patterns, phrase data, audio 
loops and image data) is reserved by Roland 
Corporation.
• Purchasers of this product are permitted to 
utilize said content (except song data such 
as Demo Songs) for the creating, performing, 
recording and distributing original musical 
works.
• Purchasers of this product are NOT permitted to 
extract said content in original or modied form, 
for the purpose of distributing recorded medium 
of said content or making them available on a 
computer network.
• This product contains eParts integrated software 
platform of eSOL Co.,Ltd. eParts is a trademark of 
eSOL Co., Ltd. in Japan.
• The Bluetooth® word mark and logos are 
registered trademarks owned by Bluetooth 
SIG, Inc. and any use of such marks by Roland is 
under license
• This Product uses the Source Code of μT-Kernel 
under T-License 2.0 granted by the T-Engine 
Forum (www.tron.org).
• This product is using the Jansson (http://www.
digip.org/jansson/) source code. 
Copyright © 2009-2014 Petri Lehtinen <petri@
digip.org> Released under the MIT license 
http://opensource.org/licenses/mit-license.php
• Roland, SuperNATURAL are either registered 
trademarks or trademarks of Roland Corporation 
in the United States and/or other countries.
• Company names and product names appearing 
in this document are registered trademarks or 
trademarks of their respective owners.