Ronbow 711040 Assembly instructions

INSTALLATION AND CARE GUIDE
ELECTRICAL OUTLET BOX
711040

170726
ronbow.com
INSTALLATION SHEET
1
ELECTRICAL OUTLET BOX
Model : 711040
Tools Required
PRE-INSTALLATION
Step 1: Figure 1.
Use the pencil & outlet box to mark out the corners
of your desired electrical outlet box location
Note: If you plan to use this outlet box with appliance
with ALCI plug, make sure to take the size of ALCI
plug into account when deciding on the
placement.
ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENSED ELECTRICIAN.
WARNING: Wire devices in accordance with the NEC. If you are not sure about existing conductor wires,
color coding, polarity and circuit feed contact a licensed electrician.
CAUTION: Requires 120V 15AMP circuit.
CAUTION: To be installed and/or used in accordance with appropriate electrical codes and regulations.
CAUTION: To avoid fire, electrical shock and/or electrocution turn power OFF at the circuit breaker before
wiring.
SPECS:
Input Voltage: 1250W,(125V 10A)
USB Input: AC 100-240V
USB Output:5V 1A Max Per Port, Total of 5W
SURFACE MOUNT ONLY
120VAC
20A GFI
CIRCUIT BREAKER FIELD CONNECTION
Black = Ground
Red = Positive
White = Negative
Black = Ground
Red = Positive
White = Negative
ELECTRICAL OUTLET BOX
OUTLET
BOX
See Figure 1.

170726
ronbow.com
INSTALLATION SHEET
2
ELECTRICAL OUTLET BOX
Model : 711040
Step 2:
INSTALLATION
Figure 2.
Use cloth with dabs of isopropyl alcohol to clean o
the surface.
When surface is cleaned, remove the 3M tape cover
on the back of the outlet box
Step 3: Figure 3.
Prior to installing the electrical outlet box, please
make sure the grounded contract opening towards
the bottom of the drawer like picture indicated on
the right.
Match your electrical outlet box to your desired
location, and press the box firmly to the mounting
surface
Note: Grounded contract opening
towards the bottom of the drawer
Note: On/O/Reset button is located in
between of the two outlet.
See Figure 2.
See Figure 3.

170726
ronbow.com
INSTALLATION SHEET
3
ELECTRICAL OUTLET BOX
Model : 711040
Step 4: Figure 4.
Remove the 3M tape cover on the back of the cord
clip, and place it at your desired wire path.
Step 5: Figure 5.
Connect the wire to your home electrical wiring as
indicated on the right:
White- Negative
Green- Ground
Black- Positive
CAUTION: ALL WIRING SHOULD BE DONE BY A
QUALIFIED LICENSED ELECTRICIAN.
WARNING: To reduce the risk of electrical shock,
shut o power before wiring the outlet box.
See Figure 4.
See Figure 5.
INSTALLATION - CONTINUE