ROOMS TO GO 3607 User manual

1. We recommend that you assemble this product with the assistance of another person. This will make
the assembly easier, and will help you prevent damage to the product or injury to persons during assembly.
2. Be sure to check all packing materials carefully for small parts that may have come loose inside the carton
during shipment.
3. Please do not over tighten screws or bolts.
4. Please put all parts on a non-abrasive floor before assembly, and follow the assembly steps to assemble your
newly purchased product correctly and efficiently.
Caution: Please read the instructions thoroughly before unpacking and assembly. Sharp,
exposed staple tips can cause injury, therefore, for your protection, please remove
any exposed staples used in the packaging.
BOLT (Ø5/16 in.-20 TPI x 60mm)

This step needs installation of four Nut s (#2).
This step needs installation of two Bolts (#1) and four Bolts (#3) .
Attach the Seat Cushion (B) to the Chair Back (A) w ith Bolts (1) &
Bolts (3), and loosely screw in bolts by using Allen Wrench (5).
DO NOT FULLY TIGHTEN BOLTS (1 & 3) AT THIS TIME .
Step 2:
Step 1: Attach Front Legs (C) to Seat Cushion (B) w ith Nuts, Spring Washers and
Flat Washers (2), and loosely tighten them by using Hexagon Wrench (6).
Next, insert Stretchers (D) into Chair Back (A) and the Front Legs (C).
NOTE: DO NOT use Screws (4) at this step.
NOW FULLY TIGHTEN BOLTS (1 & 3) AND NUTS (2) AT THIS STEP.
C
C
Now your dining chair is ready to be used.
Repeat the steps to assemble the other dining chair(s).
6
2
Unpack the carton and place all parts on a non-abrasive floor.
Assembly is now completed! Thank you for choosing this quality product!
B
A
3
5
1
4
4
4
4
Use Screws (4) to fully tighten Stretchers (D) into Chair Back (A) and
Front Legs (C).
Step 3:
This step needs installation of four Screws (#4).
A
A
B
D
C
D