ROOMS TO GO E180D-04 User manual

1
ASSEMBLY INSTRUCTION
E180D-04 CHOP END TABLE
A
Stretcher
B
Stretcher
C
Stretcher
D
Stretcher
2pcs
4pcs
2pcs
4pcs
E
Connector Tube
F
Glass Top
G
Long Bolt w/Stopper
H
Nut
493mm
1/4“
12pcs
1pc
4pcs
4pcs
I
Glass Pad
J
Open Wrench
K
Plastic Cap
20mm
10mm
3/8”
4pcs
1pc
4pcs
This page lists all the contents included in the box.
Please take the time to identify the hardware as
well as the individual components to this product.
As you unpack and prepare for assembly, place
the contents on a carpeted or padded area to
protect them from damage.

2
*** Do not tighten screws & bolts until the entire unit is completely assembled.
1
Screw Long Bolts (G) into corresponding holes on the bottom of Stretchers (A) as shown and
tighten.
2
Insert attached Long Bolts (G) through the corresponding holes on Stretchers (D).
Secure Stretchers (D) to Stretchers (A), then follow with Connector Tubes (E) as shown.
G
A

3
3
Attach Connector Tubes (E) to each Long Bolt (G) and follow with Stretchers (B) as shown.
Repeat step to add another level of Stretchers (B).
4
Attach Connector Tubes (E) to each Long Bolt (G) and add Stretchers (C) as shown.
G

4
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry or
damp soft cloth. Do not use abrasive cleaners. Hardware may loosen overtime. Periodically check that all
connections are tight.
5
Attach Stretchers (D) to the Stretcher (C) as shown. Tighten Nuts (H) to fix the frame by
Open Wrench (J). Then, put Plastic Caps (K) on Nuts (H) as shown.
6
Turn the assemble frame upright and insert Glass Pads (I) into Stretchers (A) as shown,
then place Glass Top (F).
Remove drawer knob w/ washers (H) from inside of the drawer and reattach on drawer front as
shown. The desk assembly is now complete.
C
C
A