ROOMS TO GO 787-15 User manual

ASSEMBLY INSTRUCTION
This page lists all the contents included in the box.
Please take the time to identify the hardware as
well as the individual components to this product.
As you unpack and prepare for assembly, place the
contents on a carpeted or padded area to protect
them from damage.
787-15 DESK WITH POWER & USB OUTLET
1
Table Top Back Leg
Rear Stretcher
(Long)
Allen Key
M5x60mm
Lock Washer
M8
Flat Washer
M8
Front Leg L&R
Jcbc Bolt
M8x60mm
Csk-Screw
M4x38mm
Side Stretcher
(Short)
1pc
8pcs 8pcs 1pc
1pc 6pcs
2pcs 2pcs 2pcs
8pcs

2
Take the Allen Key, and turn the bolts until the legs are secured.
DO NOT TIGHTEN COMPLETELY.
Stop when you feel you are adding force to tighten the bolt.
C
A
I
F
H
G
I
F
H
G
E
C
A
J
Put the Table Top (A) upside down on the soft and smooth surface. Attach Back Leg (C)
onto Table Top (A). Then insert Jcbc Bolt (F), Lock Washer (G) and Flat Washer (H) into
holes of each corner block of Table Top (A) by using Allen Key (I). Do not fully tighten the
bolts in this step.
Insert Rear Stretcher (Long) (E) into Back Leg (C) with Csk-Screw (J) by using Screwdriver
(not included). Attach the other Back Leg (C) onto Table Top (A). Then insert Jcbc Bolt (F),
Lock Washer (G) and Flat Washer (H) into holes of each corner block of Table Top (A) by
using Allen Key (I). Do not fully tighten all screws in this step.

3
C
D
D
JJ
D
D
J
B
BI
F
H
G
A
J
Insert Side Stretcher (Short) (D) into the holes of Back Leg (C) with Csk-Screw (J) by using
Screwdriver (not included).
Insert Side Stretcher (Short) (D) into Front Leg (B) with Csk-Screw (J) by using Screwdriver
(not included). Attach the other Front Leg (B) onto Table Top (A). Then insert Jcbc Bolt (F),
Lock Washer (G) and Flat Washer (H) into holes of each corner block of Table Top (A) by
using Allen Key (I). Do not fully tighten all screws in this step.

Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean
surface with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over
time. Periodically check that all connections are tight.
4
Stand Table up on an even surface and check that it is balanced. If there is a slight wobble,
apply downward pressure in the corner where a leg is uneven. Keeping pressure in that
corner, tighten all bolts. If balanced, apply downward pressure evenly in the center and
tighten all bolts. Do not over-tighten beyond hole depth.
Turn the assembled Table to the upright position carefully. Make sure the Table is level,
and then securely tighten all bolts at this stage. Assembly is now completed.