ROOMS TO GO HMNF 129 User manual

Assembly Instruction
129
BAR TABLE
SKU# 43101295
Thank you for your purchase. Before discarding packaging material be sure you have
located all the parts including the necessary hardware and tools listed on the instruction
sheet below.
Parts List
# 1
1pc
Bar Top w/ Pads
# 2
1pc
Middle Glass Shelf w/o Label
# 3
1pc
Bottom Glass Shelf w/ Label
# 4
16pcs
2” Plastic Ring
# 5
2pcs
#5 Shelf Stretcher
# 6
2pcs
Center Shelf Stretcher
# 7
2pcs
#5 Shelf Stretcher
# 8
8pcs
Long Post
# 9
4pcs
Short Post
#10
1pc
Glass Holder
Hardware List
No Figure Description QTY No Figure Description QT
Y
A Bolt 5/16”x2-1/2” 12 D Pan Bolt
1/4”x 20 x 3/8” 4
B Pan Bolt
1/4”x 20 x 3/4” 12 E 4mm Hex Allen Wrench 1
C Washer 1/4” x 5/8” 12
Please do not tighten any bolt firmly before you put all of them in place.
HMNF

Step 1) Put all parts on a soft surface to prevent scratches and pre-assemble middle glass
shelf (#2) and bottom glass shelf (#3) as below. Attach shelf stretcher (#5), center shelf
stretcher (#6) and shelf stretcher (#7) to glass shelf (#2) & (#3) by using bolt (B) and washer
(C) as below shown then tighten all bolts firmly.
Step 2) Following below sketch and attach glass holder (#10) to bar top (#1) by using bolt
(D) as shown then tighten bolts (D) firmly. Next attach bolt (A), long post (#8) and plastic
ring (#4) to bar top (#1) one by one bottom-up accordingly. Please do not tighten bolts (A)
firmly before you put all of them in place.
E
B
C 7
5
6
2,3
↩
↩
4
8
A
1
D
E
10

Step 3) Put pre-assembled middle glass shelf (#2) on the frame then repeat to attach bolt
(A), long post (#8) and plastic ring (#4) to pre-assembled middle glass shelf (#2) one by one
bottom-up accordingly again.
Step 4) Put pre-assembled bottom glass shelf (#3) on the frame again then attach plastic
ring (#4), bolt (A) and short post (#9) to pre-assembled bottom glass shelf (#3) as below
shown.
4
8
↩
↩
4
A
2
9
↩
↩
A
4
3

Step 5) ATTENTION ! Re-checking all glass holder bolts (D) firmly and re-swivel all posts (8)
& (9) bottom-up to make all firmly enough as below shown. Turn the bar table upside down
by 2 strong persons carefully.
ATTENTION ! Checking glass holder bolts.